Installation Instructions
6
Installation Instructions
STEP 3 REMOVE KICKPLATE
• Remove the 4 toekick screws. Lift off the 2
piece toekick.
STEP 4 INSTALL 90° ELBOW
• Wrap 90° elbow with thread seal tape.
• Install a 90° elbow onto the water valve.
• Do not over tighten 90° elbow, water valve
bracket could bend or water valve fitting could
break.
• Position the end of the elbow to face the rear of
the dishwasher.
STEP 2 ADJUST LEVELING
LEGS
• Move the dishwasher close to the installation
location and lay it on its back.
• Measure installation height and dishwasher
height. Extend leveling legs out from the
dishwasher base, 1/4" less than installation
height.