…KO - SANTO 2972-6 i Integrating Fridge Freezer Operating and Installation Instructions
Dear customer, Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance.
Contents Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Appliance Packaging Information . . . . . . . . . . . . . . . . . . . . . . . . . .5 Disposal of old Appliances . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Remove transport packaging . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 Starting up and temperature regulation . .
Safety Please read this instruction book before using the appliance and retain for future reference. These warnings are provided in the interests of your safety, ensure you understand them fully before using the appliance. Intended use ¥ The appliance is intended for use in the home. It is suitable for the cooling, freezing and storing of frozen food, as well as for making ice.
cartridges etc in the refrigerator/freezer. ¥ Bottles and cans must not be placed in the freezer compartment. They can burst when the contents freeze, high carbonate content drinks can even explode! Never store lemonade, juices, beer, wine, sparkling wine etc. in the freezer compartment. ¥ Ice cream or ice cubes can cause Òfrost/freezerÓ burns if consumed straight from the freezer. ¥ Do not touch frozen food with wet hands. Your hands could stick to the food.
Warning! Before disposing of old appliances make them inoperable. Remove plug from mains, sever the power cable, remove or destroy any snap or latch closures, to prevent small children being trapped inside. ¥ Use an authorised disposal site. Contact your Local Council or Enviromental Health Office to see if there are facilities in your area to recycle the appliance. Remove transport packaging The appliance and the interior fittings are protected for transport.
Starting up and temperature regulation Wash the inside of the appliance with lukewarm water with a little bicarbonate of soda added (5ml to 0,5 litre of water). Do not use soap or detergent as the smell may linger. Dry the appliance thoroughly. ¥ When the refrigerator compartment door is opened, the internal lighting is switched on. The temperature control knob is located on the right hand side of the refrigerator compartment. Setting Ò0Ó: Off. Setting Ò1Ó: Hightest temperature, (warmest setting).
Interior Accessories Storage shelves ¥ You should always slide one of the full size glass storage shelves into the lowest set of guides, above the fruit and vegetable containers, and keep it in this position. ¥ The height of the storage shelves can be adjusted: ¥ To do this pull the storage shelf forward until it can be swivelled upwards or downwards and removed. ¥ Please do the same in reverse to insert the shelf at a different height.
Fresh food refrigeration To obtain the best performance: ¥ do not store warm food or evaporating liquid in the refrigeator ¥ do cover or wrap the food, particularly if it has a strong flavour. ¥ Position food so that air can circuiate freely round it. Useful hints: Meat (all types): wrap in polythene bags and place on the glass shelf above the vegetable drawer(s) For safety, store in this way only one or two days at the most.
¥ Allow warm food to cool down before freezing. The warmth will cause increased ice formation and increase the power consumption. ¥ Please note the maximum storage times specified by the manufacturer. ¥ Thawed foods which have not been processed further (cooked into meals) may not under any circumstances be frozen a second time. ¥ Containers with flammable gases or liquids can leak at low temperatures.
Preparation of Ice Cubes 1. Fill the ice cube tray 3/4 full with cold water, place it in the freezer compartment and leave to freeze. 2. To loosen the frozen cubes, either twist the ice cube tray or hold it under running water for a few seconds. Important! Never try to free an ice tray that is frozen to the freezer compartment using pointed or sharp edged objects. Use the ice scraper supplied. Frozen Food Symbols/Freezing Calendar ¥ The symbols on the drawers show different types of frozen goods.
1. Remove the frozen food from the freezer, wrap it in several layers of newspaper and put it in a very cool place. 2. Switch off the appliance and pull out the plug, or turn the temperature control knob to Ò0Ó. 3. Leave the freezer compartment door open. 4. Insert the plastic scraper into the recess provided under the defrost water channel and place a collecting basin under it. 5. Once defrosting is completed keep the scraper handy for future use; 6.
Cleaning and Care For hygienic reasons the appliance interior, including interior accessories, should be cleaned regularly. Warning! Before carrying out any cleaning or maintenance, disconnect the appliance from the electricity supply. ¥ Never clean the appliance with a steam cleaner. Moisture could accumulate in electrical components, which could cause an electrical shock! Hot vapours can lead to the damage of plastic parts. ¥ The appliance must be dry before it is placed back into service.
Energy Saving Tips ¥ Do not install the appliance near radiators or other sources of continuous warmth. High ambient temperatures cause longer, more frequent operation of the compressor. ¥ Ensure sufficient air circulation at the appliance base and at the back wall of the appliance. Never cover air vent openings. ¥ Do not place warm foods into the appliance. Allow warm foods to cool first. ¥ Do not leave the door open any longer than necessary. ¥ Do not set temperature any colder than necessary.
Symptom Possible Cause Remedy Temperature is not properly Please look in the "Initial adjusted. Start Up" section. Door was open for an exten- Open the door only as long ded period. as necessary. The food is too warm. A large quantity of warm food Turn the temperature control was placed in the appliance knob to a colder setting. within the last 24 hours. The appliance is near a heat Please look in the "Installasource. tion location" section. Interior lighting does not work. Light bulb is defective.
Changing the light bulb Warning! There is a risk of electric shocks! Before changing the light bulb, switch off the appliance and unplug it. Light bulb data: 220-240 V, max. 15 W 16 1. To switch off the appliance, turn the temperature control knob to position "0". 2. Unplug the mains plug. 3. To change the light bulb, remove the screw from the light bulb cover. 4. Unhook the light bulb cover as shown. 5. Change the defective light bulb. 6. Refit the light bulb cover and the screw. 7.
Service and Spare Parts If you require a service engineer or wish to purchase spare parts, contact your local AEG Service Force Centre by telephoning: 0870 5 929929 Help us to help you Please determine your type of enquiry before telephoning. When you contasct us we need to know: 1.Your name, address and post code 2.Your telephone number 3.Clear and concise details of the fault - What is the fault? - When does the fault occur? 4.The model, production number and product identification number.
Guarantee Conditions Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar documentation. The guarantee does not cover commercial use. 2. The guarantee covers all parts or components which fail due to faulty workmanship or faulty materials.
Installation Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING Ð THIS APPLIANCE MUST BE EARTHED The manufacturer declines any liability should these safety measures not be observed. Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is inside, on the left. The appliance is supplied with a 13 amp plug fitted.
Installation Location The appliance should be set up in a well ventilated, dry room. Energy use is affected by the ambient temperature. The appliance should therefore Ð not be exposed to direct sunlight; Ð not be installed next to radiators or other sources of continuous heat; Ð only be installed at a location whose ambient temperature corresponds to the climate classification, for which the appliance is designed.
P P A P1 P1 D114 Right opening Remove the pins ÒPÓ and ÒP1Ó. Left opening 1. Remove ÒPÓ from both sides and the upper door. 2. Remove middle hinge (A) from the right side refit it on the left side. 4. Refit door and ÒPÓ on the left side. 5. Remove ÒP1Ó from the right side. Housing dimensions Height Depth Width 1780 mm 550 mm 560 mm Instructions for building-in Apply joint the sealing strip as shown in figure.
Push appliance into the housing until stop strip (A) touches the kitchen unit. A D023 Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. D D723 C Apply covers (B) into the relevant holes.
Separate parts A, B, C, D as shown in the figure B A C D PR266 50mm Place guide (A) on the inside part of the furniture door, in the upper and lower positions as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. A 20 m m PR166 Fix cover (C) on guide (A) until it clips into place.
Open the appliance door and the furniture door at 90¡. Insert the small square (B) into guide (A). Put together the appliance door and the furniture door and mark the holes as indicated in the figure. Remove the squares and drill holes with ¿ 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied. 8mm A PR167 B At the end of installation/adjusting, it is necessary to check if the door of the furniture closes properly.
If the appliance is fixed to the side of the kitchen unit, simply slacken the screws in the fixing brackets (D), move the brackets as shown in the figure and re-tighten the screws. Then fit cover (E). D E D734 Regulations, Standards, Guidelines This appliance was designed for household use and was manufactured in accordance with the appropriate standards.
AEG HausgerŠte GmbH Postfach 1036 D-90327 NŸrnberg http://www.aeg.hausgeraete.