Operator`s manual

A-61371 April 2010 3-17
Specifying the interval between scanning operations
The chart below provides the time intervals that can be set between
scanning operations. The time interval is based upon how much time it
takes you to move, for example, a roll of film from frame-to-frame. Refer
to this table when making a value selection.
1. Press the 10 key to change the value to A. This enables the Cycle
Print mode.
2. Press the 1 key to change values. Each value corresponds to an
interval between scanning operations shown in the table above.
3. Press the Memory Input key to store the currently selected interval
setting of the Cycle Print mode into the memory.
Operating in the Cycle Print mode
• After entering the Cycle Print mode, press the Start key. After the first
scanning operation has finished, the system will automatically scan
the next image following a preset period of time. The system will
continue to operate until the Cycle Print mode is canceled.
The
No. of Copies value flashes during the scanning and waiting
operations.
The next scanning job can be started manually by pressing the Start
key before the system automatically initiates the same job.
To pause an operation during the Cycle Print mode:
• Press the Clear/Stop key (the
No. of Copies value switches from a
flashing display to a constant display).
While the Pause function is enabled, it is possible to exit the Cycle Print
mode by pressing the Clear/Stop key a second time (the value
displayed in the
No. of Copies display will change to a 1).
Selecting the Connection
mode
The scanner connection can be selected between PR (connection to
the printer) and PC (connection to the personal computer).
•Press the Shift key and the PC/PR key together for over one second.
PC mode — when the display is switched from Multi-Print to PC, the
connection to the PC is valid.
PR mode — when the display is switched from PC to Multi-Print, the
connection to the Printer is valid.
Value 1234567890
Period (seconds) 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0