Operator`s manual

A-61371 April 2010 5-3
Replacing the
projection lamp
Use the following procedure to replace the projection lamp whenever a
reduction in brightness on the screen is detected or whenever the lamp
burns out. Make sure that the replacement lamp is specified for use
with this scanner.
If the projection lamp burns out during a print operation, an L2 code
appears and the print job will stop (a blank piece of paper may be
output depending upon the stage of the job).
Once the system detects that the projection lamp has burnt out, the
scan job will be cancelled. If the system is operating in the Cycle Print
mode, the scanner operation will stop.
1. Turn the power switch off.
WARNING: Never touch the lamp with bare hands just after
operation or immediately after turning it off. Wait at
least 10 minutes after shutting the power off to allow
the lamp to cool down as it becomes very hot during
use.
2. Slide out the projection lamp unit.
3. Remove the projection lamp, together with the lamp socket, from
the project lamp unit.
4. Unplug the projection lamp from the lamp socket.