Operator`s manual

A-61371 April 2010 6-1
6 Troubleshooting/Messages
This chapter contains information on analyzing and correcting operating
problems or errors that may occasionally arise during the use of the
Kodak 3000 DV Plus Digital Scanner.
Printer /Scanner
malfunctions
Display Code Description
--- E1 Power to the printer is off or there is a problem with
the connection of the interface cable to the printer.
Turn on the printer or make sure that the interface
cable is securely connected.
E2 The upper cover of the printer is not closed. Make
sure that it is completely closed.
--- E3 The toner cartridge is not installed or is defective.
• Install a correct toner cartridge.
E4 A different type of toner cartridge is set.
• Install a correct toner cartridge.
You are using an end-of-life (completely used) toner
cartridge. When the Start key is pressed again it
prints. (When Clear/Stop key is pressed, the print is
cancelled.)
• Replace the toner cartridge immediately.
PE Paper Empty indicator: lights up when the printer
is not loaded with the paper size selected or when
the paper feeding tray or paper cassette has run out
of paper with Auto (auto paper selection) selected.
PF* Paper of the output bin was filled.
• Remove the paper from the output bin.
--- PC This blinks when the scanner is connected to the PC
and ready for scanning by pressing the Start key.
Pc The scanner is not connected to the PC.
• Turn on the PC or connect the scanner to the PC
with the interface cable.
L1 The lens is not mounted or is loose.
• Check the lens for correct installation and reinstall
it as necessary.
L2 The projection lamp is burned out.
• Turn the power off, unplug the power cord and
replace the lamp.
If the lamp goes out during a print cycle, a blank
print may be output.
Magnification warning display:
• You used the modification of the magnification by
an electronic zoom.
• When a standard magnification is not selected,
this symbol will be displayed.