Operator`s manual

A-61371 April 2010 B-1
Appendix B User and System Settings
This system offers these settings:
• User settings that are set up by the user from the control panel.
• Settings that are made by the user via User mode.
• System settings that are set up by the dealer.
Following is a list of factory settings:
NOTE: When any of these functions are changed, store the new setting
in the system’s memory by pressing the Memory Input key.
User Settings Initial Setting Remark
Exposure mode Auto
Print image density Center
Paper size Letter (A4)
Film type Auto
Auto Skew Correction OFF
Auto Masking OFF
Manual Masking - Enabled only when the Manual
Masking Kit (option) is mounted.
Centering/Fit OFF
Print position Center
Print mode Text
Resolution 600 dpi Kodak 34 ppm Video Laser Printer
Electrical zoom
magnification
1.00
System Setting Selection Initial
Setting
Description
Auto Reset Enabled
Disabled
200V * Setting changes made to the control panel that are not
used within 60 seconds of being input are
automatically cancelled and the system reverts back to
the original settings.
Auto power save ON/OFF Enabled
Disabled
* Sets the unit to enable or disable the Auto Power Save
mode.
Printer Heater OFF
(PR mode only)
Disabled
30 min.
60 min.
* Turns the printer’s heater off if the system is left idle for
a specific period of time.
Priority is given to the Power Save mode if Power
Save has been set.
Auto Projection Lamp OFF Disabled
30 min.
60 min.
* Turns the projection lamp off if the system is left idle for
a specified period of time.
Priority is given to the Power Save mode if Power
Save has been set.