Operator`s manual

A-61371 April 2010 D-3
Settings in each User
mode function
U1: Special Print mode — this function is not available.
U2: Engineering Enhancement mode — slight image distortion
occurring in the scan direction can be corrected with this function.
1. Select U2 in the User mode.
2. Press the Exposure Mode key to display d*.
3. Press the Exposure Adjustment key (Darker or Lighter) to select
the desired setting value.
4. Press the Start key to validate the setting.
NOTE: This setting returns to the default value when the power switch
is turned off. You can register this setting by using the Job
Program function.
U3: Auto Power Save — time it takes the unit to be automatically set
into the Power Save mode.
1. Select U3 in the User mode.
2. Press the Exposure Mode key to display d*.
3. Press the Exposure Adjustment key (Darker or Lighter) to select
the desired setting value.
4. Press the Start key to validate the setting.
Code Setting Value Initial Setting
d0 0 mm
d1 0.5 mm
d2 1.0 mm
d3 1.5 mm *
d4 2.0 mm
d5 2.5 mm
d6 3.0 mm
d7 3.5 mm
d8 4.0 mm
Code Setting Value Initial Setting
d1 Auto Power Save (15 min.) *
d2 Auto Power Save (30 min.)
d3 Auto Power Save (60 min.)