8160 D/8190 D 8260 D/8290 D 8360 D/8390 D 8361 D/8391 D Cooker Hood Campana extractora Exaustor Operating and Installation Instructions Instrucciones de montaje y manejo Manual de Instruções
Contents Safety warnings ................................................................................ 3 For the user ........................................................................................ 3 For the installer ................................................................................... 3 ............................................................................................................. Description of the Appliance .........................................................
Safety warnings For the user • The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. • Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. • Also, when frying, keep the deep frying pan on the cooker top/ cooker under careful control. • The hot oil in the frying pan might ignite due to overheating.
• The national Standard on fuel-burning systems specifies a maximum depression of 0.04 mbar in such rooms. • The air outlet must not be connected to chimney flues or combustion gas ducts. The air outlet must under no circumstances be connected to ventilation ducts for rooms in which fuel-burning appliances are installed. • The air outlet installation must comply with the regulations laid down by the relevant authorities.
Description of the Appliance • The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter. • You will need an original AEG charcoal filter for this function (Available from your local AEG Service Force Centre). Extractor version • In this version fumes are extracted to the outside via a hose connected to the coupling ring A. Fig. 1. Fig. 1 • In order to obtain the best performance the hose should have a diameter equal to the outlet hole.
Control Panel • Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared.
Control Panel 8360 D - 8361 D - 8390 D - 8391 D • Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the unit’s front panel: A B C D E F G - Mains switch, OFF.
Maintenance and care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood • Clean the outside of the hood using a damp cloth and a mild detergent. • Never use corrosive, abrasive or flammable cleaning products. • Never insert pointed objects in the motor’s protective grid. • Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders.
Charcoal filter • The charcoal filter should only be used if you want to use the hood in the recirculation function. • To do this you will need an original AEG charcoal filter (available from your local Service Force Centre). • Cleaning/replacing the carbon filter Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month (when using the hood 2,5 hours per day, in avarage).
Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb • Disconnect the cooker hood from the main supply. 8160 D - 8190 D • Remove the lamp cover. Fig. 5.
What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply. Check that a fan speed has been selected The cooker hood is not working effectively.. Check that: The fan speed is set high enough for the task. The grease filters are clean. The kitchen is adequately vented to allow the entry of fresh air.
Special accessories Charcoal KF8 E-Nr. 942 118 648 Technical assistance service (not for UK) You are welcome to telephone our technical assistance service (see list of technical assistance centres) whenever you need information or in the unlikely event of a fault. For service in Australia call 1300 650 020. When calling, please be ready to specify: 1. The model code number 2. The serial number (E-Nr.) 3. The manufacturing number (F-Nr.
Technical Details Models Dimensions (in cm) Maximum Motor Height Width Depth absorbed power power Lighting Length Electrical of the cable connection 8160 D 80-135 59,8 47 170 W 1 x 155 W 1 x 11 W (PL) 150 cm 220-240 V 8190 D 82-137 89,8 48 170 W 1 x 155 W 150 cm 220-240 V 8260 D 80-135 59,8 47 200 W 1 x 155 W 2 x 20 W (G4) 150 cm 220-240 V 8290 D 82-137 89,8 48 200 W 1 x 155 W 2 x 20 W (G4) 150 cm 220-240 V 8360 D 80-135 59,8 47 175 W 1 x 130 W 2 x 20 W (G4) 150 cm 220-240 V 8
Electrical connection (not for UK) Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. Should it be necessary to provide a fixed connection, the hood must only be installed by an electrician authorised by the local electricity board.
Wall unit mounting - Fig. 7 • Position the template on the wall (1) and mark the position, and drill (2) the holes (2 x Ø 8 mm). • Mount the two wall plugs with the hooks (3). • Hang the hood on the hooks and level it with the adjustment screws (4). • Remove the grease filters (5) and mark for the two screws (6). Remove the hood and drill the holes (2 x Ø 8 mm). Insert the rawl plugs (7) and hang the hood on the wall again. Adjust it with the screws (8) and secure it with the screws (9).
Electric hob Gas hob Fig.
Exhaust tube Power outlet Electric hob Gas hob 500 mm 650 mm 22 240 Wall bracket 270 370 8190 D 8290 D 8390 D 8391 D 350 8160 D 8260 D 8360 D 8361 D 599-899 Electric hob Gas hob 500 mm 650 mm 17
From the Electrolux Group. The world´s No.1 choice. The Electrolux Group is the world´s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group products (such as refrigerators, cookers, washing machines,vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx. USD 14 billion in more than 150 countries around the world. AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de http://www.aeg.co.
