32984350.qxd 20/07/2005 11.
132984350.qxd 20/07/2005 11.02 Pagina 2 Important Safety Information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings.
132984350.qxd 20/07/2005 11.
132984350.qxd 20/07/2005 11.02 Pagina 4 Your New Washer-Dryer Your new machine meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. It is gentle with your laundry, simple to use and easy to care for. ● ● ● ● Programme and temperature setting using the programme selector. The special wool programme with its new delicate wash system treats your woollens with extreme care.
132984350.qxd 20/07/2005 11.
132984350.qxd 20/07/2005 11.02 Pagina 6 The Control Panel EWD 1214 I 1000 1 2 3 4 5 6 7 8 9 1 Detergent dispenser drawer 10 6 Super Rinse button By depressing this button on programmes for cottons and linens the machine will perform an additional rinse. This is recommended for people who are allergic to detergents and in areas where the water is very soft. 2 Drying indicator light This light illuminates when the machine is drying.
132984350.qxd 20/07/2005 11.02 Pagina 7 Operating Sequence 3. Measure out the fabric softener Before the first wash, we recommend that you run a cotton cycle at 95°C, without any laundry in the machine, to remove any manufacturing residue from the drum and tub. Pour 1/2 a measure of detergent into the dispenser drawer and start the machine. If required, pour fabric softener into the compartment marked (the amount used must not exceed the “MAX” mark in the drawer). Close the drawer gently.
132984350.qxd 20/07/2005 11.02 Pagina 8 6. Start the machine Before starting up the machine check that: the appliance is plugged in ● the water supply taps are turned on ● the drain hose is correctly and securely positioned ● the door and the detergent dispenser drawer are closed. Depress the ON/OFF button .: the mains-on light will ill uminate and the machine starts operating. ● P0471 7. At the end of the programme The machine stops automatically.
132984350.qxd 20/07/2005 11.02 Pagina 9 4. Select the required programme WASHING 2 KG OF MIXED FABRICS AT 50°C Suppose you have 2 kg of mixed fabrics to wash. They are rather delicate fabrics and should not be washed at a high temperature. Turn the programme selector dial clockwise to the programme H. H 1. Load the laundry Open the door by pulling the catch outward. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door. P0673S 5.
132984350.qxd 20/07/2005 11.02 Pagina 10 4. Start the machine DRYING 2.5 KG OF COTTON You have for example just machine-washed and spun at 1200 rpm 5 kg of laundry. They are cotton fabrics of medium weight which you want to iron as soon as they are dry. Switch off the machine. Then remove the laundry from the appliance and divide the items to obtain two loads of approx. 2.5 kg each. Depress the ON/OFF button , the mains-on light and drying light will illuminate and the machine starts operating. 1.
132984350.qxd 20/07/2005 11.02 Pagina 11 5. Select the required time AUTODRYING 1 KG OF MIXED FABRICS You intend to wash and dry automatically 1 kg of mixed fabrics which have to be ironed. Proceed as follows: Following indications given in the programme chart on page 16, turn the time selector dial clockwise to the 40 mins setting in the green sector. 1. Load the laundry 40 60 Open the door by pulling the catch outward. Load the items one at a time and close the door. 2.
132984350.qxd 20/07/2005 11.02 Pagina 12 Washing and Drying Hints Do NOT overload the machine. Weigh the laundry the first few times you use the appliance.
2984350.qxd 20/07/2005 11.02 Pagina 13 Which detergent?.... And in which form? To ensure you obtain the best wash results from your appliance, it is important to use the right detergent in your everyday wash, and only detergents recommended for use in automatic machines. To maintain the appearance of your clothes and household textiles and to make them last longer you should use different types of detergent for different washes, whether for whites, colours or delicates.
132984350.qxd 20/07/2005 11.02 Pagina 14 Washing Programmes Programmes for cotton and linen Max. Progr. time load mins. Programme dial position Description A Prewash at 40 °C Wash at 95 °C 3 rinses, Long spin at 1200 rpm 5 kg 25 B Wash at 95 °C 3 rinses Long spin at 1200 rpm 5 kg 125 C(*) Wash at 60 °C 3 rinses Long spin at 1200 rpm 5 kg 140 Non fast coloured NON- FAST cotton or linen fabrics, COLOUREDS shirts, blouses, underwear.
132984350.qxd 20/07/2005 11.02 Pagina 15 Washing Programmes Programmes for synthetics, mixed fabrics, delicates and wool Important: When the automatic NON-STOP washing plus drying programme is used for synthetics, there is a short spin at 850 rpm before drying starts. Wash programme Degree of soil and type of laundry Synthetic or mixed fabrics, underwear, SYNTHETICS coloured garments, non-shrink shirts, blouses. RINSES Max. Progr. time load mins.
132984350.qxd 20/07/2005 11.02 Pagina 16 Drying Programmes Degree of drying Programme/ Type of fabric Max. load Spin speed Drying time mins 2.5 kg 1200 100-110 Cotton and linen (towels, T-shirts, bathrobes) 1.5 kg 1200 55-65 L 1.5 kg 850 100-110 1 kg 850 55-65 2.5 kg 1200 70-80 Cotton and linen (sheets, tablecloths, shirts, etc.) 1.5 kg 1200 40-50 L 1.
132984350.qxd 20/07/2005 11.02 Pagina 17 Wash Care Symbols Wash care labels inside garments recommend how to launder your clothes with the best results. The care labelling code is in line with care labelling used in the rest of Europe. The symbols used make it easy to select the correct programme on your washing machine.
132984350.qxd 20/07/2005 11.02 Pagina 18 Maintenance and Cleaning Before any maintenance or cleaning is carried out you must DISCONNECT the appliance from the electricity supply. Descaling The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine. Do this separately from any laundry washing, and according to the softening powder manufacturer's instructions. This will help to prevent the formation of lime deposits.
132984350.qxd 20/07/2005 11.02 Pagina 19 Unscrew and remove the filter. Clean carefully under a fast running tap. Clean the filters using a hard bristle brush. Tighten up the inlet hoses. P1090 P0040 P0039 The dangers of freezing Warning If the machine is exposed to temperatures below 0°C, certain precautions should be taken. ● Turn off the water taps. ● Unscrew the inlet hoses. ● Unhook the drain hose from the rear support and position the end of this hose and that of the inlet hose in a bowl.
132984350.qxd 20/07/2005 11.02 Pagina 20 Something Not Working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Electrolux Service Force Centre, please carry out the checks listed below. IMPORTANT: if you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.
132984350.qxd 20/07/2005 11.02 Pagina 21 Symptom Possible causes The door will not open ● ● ● The programme is still running. The door lock has not yet released. There is water in tub. The machine makes an unusual noise ● The machine is fitted with a type of motor which makes an unusual noise compared with other traditional motors. This new motor ensures a softer start and more even distribution of the laundry in the drum when spinning, as well as increased stability of the machine.
132984350.qxd 20/07/2005 11.
132984350.qxd 20/07/2005 11.02 Pagina 23 Installation Instructions It is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person.
132984350.qxd 20/07/2005 11.03 Pagina 24 Set the machine upright and remove the two remaining bolts from the back. Pull out the three plastic spacers from the holes into which the bolts were fitted. Plug the open holes with the plugs which you can find in the envelope containing the instruction booklet. Unpacking All transit bolts and packing must be removed before using the appliance. You are advised to keep all the packaging for re-use in case the machine is to be transported again.
20/07/2005 11.03 Pagina 25 If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system. There should be a minimum distance of 5.02m (16.5 ft) between the appliance’s inlet and the bottom of the water storage tank. Set the hoses correctly by loosening the ring nuts. After positioning the inlet hoses, be sure to tighten the ring nuts again to prevent leaks.
132984350.qxd 20/07/2005 11.03 Pagina 26 Special conditions If the floor is carpeted or covered with crumbly or soft material, insert a rigid support base under the feet to prevent noise, vibration or displacement. The base should protrude a few centimetres beyond the edges of the machine. Loop Warning The machine should NOT be placed on deep pile carpeting. P1198 The drain hose may be extended to a maximum of 4 metres.
132984350.qxd 20/07/2005 11.03 Pagina 27 Electrical connection The wire coloured green and yellow must be connected to the terminal marked with the letter «E» or by the earth symbol or coloured green and yellow. The wire coloured blue must be connected to the terminal «N» or coloured black. The wire coloured brown must be connected to the terminal marked «L» or coloured red. Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.
11.03 Pagina 28 Building-in The height (C-Fig. C) depends on the height of the adjacent furniture's base. This appliance has been designed to be built into the kitchen furniture. The recess should have the dimensions shown in picture A. 35 Ø 12.5-14 depth 16 -22 B 20/07/2005 416 600 600 570 min. 120 176,5 416 818 ,5 22+1 820 min 596 515 98 595-5 1 C P0422S 160 195 54 8 C 132984350.qxd 165 90 0 49 P0965 b) Hinges To mount the hinges it is necessary to drill two holes (dia.
132984350.qxd 20/07/2005 11.03 Pagina 29 Position the base into the recess with its front edge as far forward as the adjoining plinth line will allow. If the door has to be opened from left to right, invert the position of the plates (7), the magnet (4) and the plate (5) (Fig. B and E). Mount the countermagnet (6) and the hinges (1) as previously described. E 6 4 5 7 The reason for placing the base in this position is to allow a small strip of beading to be fitted in front of the appliance feet.
132984350.qxd 20/07/2005 11.
