Use a Care Guide Wine Cooler Guia de Uso y Cuidado Refrigerador de Vinos Guide D'utilisation et D'entretien Refroidisseur 5 Vin Electro|ux 241957000 May 2008
Finding information Please Read and Save This Guide Thank you for choosing Electrolux, the new premium brand in home appliances. This Use & Care Guide is part of our commitment to customer satisfaction and product quality throughout the service life of your new wine cooler. We view your purchase as the beginning of a relationship. To ensure our ability to continue serving you, please use this page to record key product information.
Fin ing information Table of Contents Finding Information ................................................................................. PleaseReadand SaveThis Guide ...................................................................................... Make a Record for Quick Reference................................................................................... Product Registration Card.................................................................................................. Questions?.....
Safety important Safety Safety Instructions Precautions Do not attempt to install or operate your unit until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a Danger, Warning or Caution based on the risk type. Definitions This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.
Installation installing the Wine Cooler Your Electrolux wine cooker has been designed for either free-standing or built-in installation. When builtin, your wine cooler does not require additional air space for top, sides or rear. In either case, the front grille must NOT be obstructed. NOTE To ease unit installation and removal, it is recommended that the cabinet rough opening dimensions be increased by at least 1A inch over the dimensions given for your unit.
Installation NOTE All units require zero clearance when installed flush with a cabinet or wall. Electrolux ICON Pro stainless steel models require a minimum 2 _1/leinch handle clearance when installed against a wall or cabinet that extends beyond the front edge of the unit.
Installation Site Preparation 1 Position the unit on a flat, level surface capable of supporting the entire weight of the unit. Remember the unit will be significantly heavier once it is fully loaded. 2 This unit requires a grounded and polarized 115 VAC, 60Hz, t5A circuit (normal household current). 3 Avoid connecting the unit to a Ground Fault Interruptor (GFI).
Levelin Leveling the Unit Position the unit on a flat, level surface capable of supporting the entire weight of the unit when full. This unit contains four (4) adjustable leveling legs, Turn the legs clockwise to raise and counterclockwise to lower.
Door Reversal Reversing Remove upper right-hand (RH) hinge bracket by loosening four (4) screws. Be careful to support the door while loosening and removing the upper hinge bracket. the Door This model comes equipped with a RH-swing door. To convert the unit to a LH-swing door (as shown in the Use & Care Guide), certain components must be obtained before beginning the conversion. These components are available from your local dealer or by calling Electrotux.
Door Reversal 6 Remove access cover by removing two (2) screws. 7 Shift door harness from one side to the other. 9 Install metal left-hand (LH) door stop by installing screw. 10 Install plastic LH door stop by installing screw. 11 Remove lower RH door hinge by removing two (2) screws. Remove P-clamp and install in LH side, 12 Install lower LH door closer in lower LH door Replace access cover. hinge by installing screw. 13 8 Remove plastic RH door closer by removing screw.
Door Reversal 14 Remove button plug from upper left side of door and place in upper right side of door. Place door on lower LH hinge bracket. 15 Install upper LH hinge bracket by installing four (4) screws. tf door does not close properly after reversing, the following actions may be taken: a) Loosen lower hinge screws and align door. Retighten screws. b) Loosen upper hinge screws and align door. Retighten screws. c) Remove door gasket, turn 180 °, and reinstall.
2 Door Reversal 17 Reattach toe grille by installing two (2) screws.
Start-Up an Temperature Control Starting the Unit Your wine cooler is shipped in the ON position; however, you may turn it ON or OFF by pressing and holding the ON/OFF for three (3) seconds and then releasing the key. Adjusting the Temperature To accurately check the temperature, insert a reliable thermometer into a plastic (non-breakable) bottle, partially filled with water. Tighten the bottle cap securely. Place the bottle in the desired area for 24 hours.
4 Operation Description of Features vacation mode Conserves energy by disabling interior lights and keypad inputs. mute sounds Tonesemitted by each keypress can be turned off based on user preference. The sounds are muted when the red indicator is lit. The mute sounds key also is used to acknowledge alarm conditions, denoted by a flashing red indicator. Press and hold the mute sounds key for three (3) seconds to enable control lock, which prevents undesired changes to the unit settings.
Storage Proper Storage The wine cooler will accommodate 48 bottles (750 ml size), There are five (5) upper racks that will hold eight (8) bottles each and two lower racks that wilt hold four (4) bottles each, Specially designed wine racks allow for proper horizontal storage of the wine.
6 aintenance Maintaining Your Wine Cooler Periodic cleaning and proper maintenance will ensure efficiency, top performance, and long life. The maintenance intervals listed are based interior Cleaning - as Required 1 Disconnect power to the wine cooler. 2 Remove racks if desired, see "WINE RACK RE MOVALa NSTALLATIO N" below. on normal conditions. You may want to shorten the intervals if you have pets or other special considerations.
7 Troubleshootin Before You Call for Service If Service is Required If the unit appears to be malfunctioning, read through this manual first. If the problem persists, check the Troubleshooting Guide below. Locate the problem in the guide and refer to the cause and its remedy before calling for service. The problem may be something very simple that can be solved without a service call. Some remedies listed in the Troubleshooting Guide are very complex.
Warranty information REFRIGERATOR WARRANTY WARRANTY PERIOD Your refrigerator is protected by this warranty THROUGH OUR AUTHORIZED SERVICERS, WE WILL: THE CONSUMER WILL BE RESPONSIBLE FOR: One year from odginal purchase date. Pay all costs for repairing or replacing any parts el thisappliance which prove to be defective in materials or workmanship. Excludes original and replacement Ice & Water filter cartridges (if equipped).