Gebrauchsanweisung , Notice d'utilisation et d'installation EFC 6410-6405-9410-9405-650-950 CH 1200-900-600 Istruzioni per l'uso , User manual D F I UK
Contents UK Safety warnings ................................................................................................................................................... 30 For the installer ...................................................................................................................................................... 30 For the user ..................................................................................................................................................
Safety warnings For the installer • When the hood is used in its extractor function, the following rules must be followed to obtain optimal operation: — short and straight outlet hose — keep bends in outlet hose to a minimum — never install the hoses with an acute angle, they must always follow a gentle curve. — keep the hose as large as possible (preferably the same diameter as the outlet hole).
Description of the appliance • The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter. • You will need an original ELECTROLUX charcoal filter for this function (Available from your local ELECTROLUX Service Force Centre).
Control Panel • Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared.
Maintenance and care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood Warning • Clean the outside of the hood using a damp cloth and a mild detergent. • Never use corrosive, abrasive or flammable cleaning products. • Never insert pointed objects in the motor’s protective grid. • Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders.
Charcoal filter • The charcoal filter should only be used if you want to use the hood in the recirculation function. • To do this you will need an original ELECTROLUX charcoal filter (available from your local Service Force Centre). • This filter cannot be cleaned or reused. • As a general rule, the activated carbon filter should be changed once every four months. • Mounting — Fig.
What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply. Check that a fan speed has been selected The cooker hood is not working Check that: The fan speed is set high enough for the task. The grease filters are clean. The kitchen is adequately vented to allow the entry of fresh air.
Technical assistance service (not for UK) You are welcome to telephone our technical assistance service (see list of technical assistance centres) whenever you need information or in the unlikely event of a fault. For service in Australia call 1300 650 020. When calling, please be ready to specify: 1. The model code number 2. The serial number (E-Nr.) 3. The manufacturing number (F-Nr.) This information is shown on the registration plate inside the unit behind the grease filter.
GUARANTEE CONDITIONS Standard guarantee conditions We, Electrolux, undertake that if within 12 months of the date of the purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: The appliance has been correctly installed and used only on the electricity supply stated on the rating plate.
Installation Unpacking Check that the cooker hood has no damages. Transportation damages should immediately be reported to the one responsible for the transport Damages, faults and eventually missing details should immediately be reported to the seller. Take care of the packing material so that small children cannot play with it. Placement The hood is to be mounted on the wall. When installed, the hood must be not less than 60 cm. above electric burners or 75 cm. above gas or mixed-fuel burners (fig. 7).
Installation Wall unit mounting - Fig. 8 • Put the template onto the wall (1) and drill two Ø12mm holes (2). • Fit two hooks (3) on the drilled holes. • Remove the metal filters (4) and hang the hood on the hooks and adjust the position of the hood using the two screws on the bottom of the hooks (5). • Mark 2/4 points (6). Remove the hood and drill 2/4 Ø8mm holes on the marked points. Fit 2/4 Ø8mm wall dowels, Hang again the hood and fix the hood definitively with 2/4 screws 5X45 (7).
LI1AQB Ed.