Installation Guide

8
Unpacking Washer
Removing foam
packaging
1. Temporarily re-
move door tape.
2. Open washer
door and remove
everything from
the drum.
3. Close door and
reapply door
tape.
CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more
than one person move or lift the washer.
4. Using a rug,
blanket or piece
of cardboard to
protect the floor,
carefully lay the
washer on its
back.
IMPORTANT
Save styrofoam base and shipping plug
for use to help prevent washer damage
during any future moves.
IMPORTANT
DO NOT tip washer upside down onto its
top or onto its right side for any reason.
WARNING
ELECTRIC SHOCK HAZARD
Certain internal parts are intentionally
not grounded and may present a risk of
electrical shock if contacted during in-
stallation.
Do not contact the following parts while
the appliance is energized
• Pump
• Drive motor
• Electrical control boards
• Water valves
5. Remove styrofoam base and shipping
plug and set them aside.
6. Carefully
return the
washer to
an upright
position.
WARNING
SUFFOCATION HAZARD
Dispose of the carton and plastic bags after
the washer is unpacked. Children might use
them for play. Cartons covered with rugs,
bedspreads, or plastic sheets can become
airtight chambers causing suffocation.
Place all materials in a garbage container
or make materials inaccessible to children.
IMPORTANT
DO NOT place the washer onto its back
without the shipping bolts.
7. Carefully move the washer to within 4
feet (1 m) of its final location.