Installation Guide

17
Rubber Washers
MUST BE PRESENT
NOTE
If you were able to install the “Y” connec-
tor directly to the COLD water supply,
please skip to step 8.
Installation Instructions
6. If there is not room to install the “Y”
connector directly, thread the short
extension hose on to the COLD water
supply and snug it by hand; then
tighten it another 2/3 turn with pliers.
7. Thread the “Y” connector to the short
extension hose and snug it by hand;
then tighten it another 2/3 turn with
pliers.
8. Connect the COLD inlet hose for the
washer to the “Y” connector and snug
it by hand; then tighten it another 2/3
turn with pliers.
9. Connect the straight end of the long
hose from the kit to the other outlet
on the “Y” connector and snug it by
hand. Connect the hose’s 90° cou-
pling to the brass water inlet on the
back of the dryer and snug it by hand.
Tighten each connection of the dryer
inlet hose another 2/3 turn with pliers.
Water connection, continued
(Steam Model only)
4. Inspect hose couplings for proper
placement of rubber washers. Use
hoses from ASSEMBLY HOSE KIT #
5304495002 (not included).
3. Momentarily turn on COLD supply
and run some water into a bucket or
container to clear any contaminants in
the line.
5. If your installation has room for the
COLD water supply to accept the “Y”
connector directly, thread the “Y” con-
nector to the COLD water supply and
snug it by hand; then tighten it another
2/3 turn with pliers.
10. Turn on the water and check for leaks
at all connections.
Cold Inlet Hose
to Washer
Rubber Washer
Must be Present
and Undamaged
Hose Extension
Water Inlet
on Dryer
Cold Water Supply
Hose to Washer
“Y” Connector