Installation Guide

18
Installation Instructions
General installation
1. Connect the exhaust duct to the out-
side exhaust system. Use of a 4” (102
mm) clamp (item A) is recommended to
connect the dryer to the exhaust vent
system. Use metal foil tape to seal all
other joints.
2. Use a carpenter’s level to level your
dryer front-to-back and side-to-side.
3. Use adjustable pliers to adjust the
leveling legs so the dryer is level front-
to-rear and side-to-side, and stable
corner-to-corner.
4. Press down on alternate corners and
sides and feel for the slightest move-
ment. Adjust the appropriate leg(s) so
the dryer sits solidly on the floor on
ALL four legs. Keep the leveling leg
extension at a minimum for best perfor-
mance of the dryer.
5. Plug the power cord into a grounded
outlet.
CAUTION
When discarding or storing your old dry-
er, remove the door.
IMPORTANT
Be sure the power is off at a circuit
breaker/fuse box before plugging the
power cord into an outlet.
6. Turn on the power at the circuit
breaker/fuse box.
7. Read the Use & Care Guide provided
with the dryer. It contains valuable and
helpful information that will save you
time and money.
8. If you have any questions during initial
operation, please review the “Avoid
Service Checklist” in your Use & Care
Guide before calling for service.
9. Place these instructions in a location
near the dryer for future reference.
NOTE
A wiring diagram and technical data
sheet are located under the dryer top
panel.
WARNING
Improper grounding of the dryer may
cause serious injury or death. Check with
a licensed electrician if you are in doubt
as to whether the appliance is properly
grounded.