EN BEVERAGE CENTER FR CENTRE DE BOISSONS ES CENTRO DE BEBIDAS USE AND CARE GUIDE GUIDE D’UTILISATION ET D’ENTRETIEN GUIA DE USO Y CUIDADO 242332700 June 2014
Finding Information Please Read and Save This Guide Product Registration Card Thank you for choosing Electrolux, the new premium brand in home appliances. This Use & Care Guide is part of our commitment to customer satisfaction and product quality throughout the service life of your new beverage center. We view your purchase as the beginning of a relationship. To ensure our ability to continue serving you, please use this page to record key product information.
Finding Information Table of Contents Finding Information.......................................................................2 Please Read and Save This Guide...................................................2 Make a Record for Quick Reference................................................2 Product Registration Card...............................................................2 Questions?......................................................................................2 Safety.....................
Safety Important Safety Instructions Safety Precautions Do not attempt to install or operate your unit until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a Danger, Warning or Caution based on the risk type. General Precautions WARNING RISK OF CHILD ENTRAPMENT. Before you throw away your old appliance, take off the doors and leave shelves in place so that children may not easily climb inside. Definitions This is the safety alert symbol.
Installation Installing the Beverage Center Your Electrolux beverage center has been designed for either free-standing or built-in installation. When built-in, your beverage center does not require additional air space for top, sides or rear. In either case, the front grille must NOT be obstructed. NOTE To ease unit installation and removal, it is recommended that the cabinet rough opening dimensions be increased by at least ¼ inch over the dimensions given for your unit.
Installation Site Preparation 1 2 3 4 Position the unit on a flat, level surface capable of supporting the entire weight of the unit. Remember the unit will be significantly heavier once it is fully loaded. This unit requires a grounded and polarized 115 VAC, 60Hz, 15A circuit (normal household current). Avoid connecting the unit to a Ground Fault Interrupter (GFI). GFIs are prone to nuisance tripping which will cause the unit to shut down.
Installation CAUTION Any finished flooring should be protected with appropriate material to avoid damage when moving the unit. Floor Mount Installation The anti-tip bracket is to be located on the floor in the left or right rear corner of the beverage center as shown in Figure 6. Step by step instructions for locating the position of the bracket: 1 Decide where you want to place the beverage center. Slide it into place, being careful not to damage the floor, leaving 1" (2.
Leveling Leveling the Unit Position the unit on a flat, level surface capable of supporting the entire weight of the unit when full. Leveling Legs Adjustable legs at the front and rear corners of the appliance should be set so the unit is firmly positioned on the floor and level from side to side and front to back. The overall height of your Electrolux appliance may be adjusted between the minimum, 33 ¾” (85.7cm),by turning the leveling leg in and the maximum, 34 ¾” (88.
Operation Temp Temp On/Off Minus Plus Keypad Keypad Keypad Lock Keypad Display Area on-off light alarm reset lock System Status Indicators door ajar power failure temp air filter Figure 8 Electronic Control Display Power Failure on-off To wake the display press any keypad. A confirm tone will sound, and the current storage compartment temperature will be displayed. alarm reset Starting your appliance: Plug the appliance power cord into a 115 volt wall outlet.
Operation on-off Adjusting the temperature: To set or check the set-point temperature (with the control out of sleep mode), press the "-" or "+" keypads. "SET" will be indicated on the user interface panel and the current set-point temperature will display and flash. Subsequent presses of the "-" or "+" keypads will adjust the temperature colder or warmer respectively.
Operation 11 Alarms The control will alert you to conditions that could adversely affect the performance of the appliance. Door Ajar on-off alarm reset Door ajar - If the door is open, or not closed properly, for more than five minutes the System Status OK indicator will turn-off, the "Door Ajar" indicator will flash, and a tone will sound every 60 seconds. Additionally, an "ALARM RESET" indicator will be displayed below the "On/ Off" keypad.
Operation Air Filter on-off alarm reset Air Filter - The control will notify you as to when it is time to replace the air filter (every six months). The System Status indicator will turn off and the "Air Filter" indicator will flash. Additionally an "ALARM RESET" indicator will be displayed below the "ON/OFF" keypad. No audible tone will sound. The air filter condition can be reset by momentarily pressing the "ON/OFF" keypad and the alarm will then display after another six months.
Storage 13 Proper Storage Figure 12 Display Rack The bottom rack in your beverage center is designed for storage as well as for display purposes. The unit holds five standard size wine bottles in the display rack. Stocking Recommendations The two sliding glass shelves can easily be converted to wine storage by removing the glass panels. The wine racks allow for the proper horizontal storage of wine.
Storage CAUTION Make sure your cantilever shelf is secure on the shelf supports by pressing down on the shelf before loading the shelf. To Add or Remove a Shelf: Remove stored product from the shelf. Do not try to remove a loaded shelf from the appliance. Grasp the shelf front with both hands, rotate the front upward and lift out. (See Figure 13b).
Maintenance 15 Maintaining Your Beverage Center Interior Cleaning - as Required 1 Periodic cleaning and proper maintenance will ensure efficiency, top performance, and long life. The maintenance intervals listed are based on normal conditions. You may want to shorten the intervals if you have pets or other special considerations.
Maintenance Door Alignment The door should be parallel to the sides and top of the appliance. If alignment is necessary the door may be adjusted by removing the grille, then loosening the 2 screws which secure the door adjustment bracket on the bottom of the door (see Figure 15a) and adjusting the door side to side. Use a 5⁄32” allen wrench for this procedure. (See Figure 15 below). When finished aligning the door, tighten the screws securely and install the grille.
Troubleshooting 17 Before You Call for Service If Service is Required If the unit appears to be malfunctioning, read through this manual first. If the problem persists, check the Troubleshooting Guide below. Locate the problem in the guide and refer to the cause and its remedy before calling for service. The problem may be something very simple that can be solved without a service call. Consulting or contracting a qualified service technician may be necessary.
Warranty Information Major Appliance Warranty Information Your appliance is covered by a one year limited warranty. For one year from your original date of purchase, Electrolux will repair or replace any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used, and maintained in accordance with the provided instructions.