Warranty

8
Operating Instructions
Status window
That STATUS window displays codes typically seen
during normal operation or programming of the
dishwasher. The STATUS window indicates the
following activity:
1h - 24h Indicates number of
delay start hours for
selected cycle.
CL Flashes once the
program has been
entered and the
START pad is pressed.
It also flashes if the
door is opened during
a wash cycle. Close
the door to begin or
continue the wash cycle.
Loc Child Lock is activated.
Minutes The cycle duration or
the remaining time.
L1 - L4 Level of Rinse Aid
Dosage.
Error indications
In the unlikely event the dishwasher malfunctions,
the STATUS window may display one of the
following codes: “i10” - refer to dishwasher won’t
run or fill and try to solve the problem “i20” - refer
to dishwasher does not drain properly and try to
solve the problem. If, after the check, the problem
remains, or if the status window shows other error
codes, contact the Electrolux Customer Care
Center at 1-877-435-3287. They will be able to
provide assistance in troubleshooting the problem
and/or locating an authorized service technician, if
needed.
Blue light indicator
When the BLUE LIGHT illuminates on the floor this
indicates that the wash cycle is complete.
NOTE
Opening the door during normal operation will
only pause the selected cycle.
NOTE
Your unit has DishSense
TM
Technology that is
used to understand how heavily soiled the dish
load is so the cycle can be automatically adjusted
to the appropriate response. This helps to
prevent energy waste. The sensor is calibrated
at the end of the cycle. For the first cycle after
power is applied (when first installed or after a
power failure) the sensor will not be calibrated
and so cannot determine the soil load. Therefore,
your unit will provide a response suitable for
heavy soils on the first run after power is restored.
This will assure that whatever is loaded will get
cleaned. Energy use during this first run may be
higher than would be typical.