Manual

cub ing
_F0r your safety, turn vacuum cleaner off and unplug power cord before attempting to resolve problems.
Problem Possible cause Solution
/
No suction; vacuum cleaner does
not pick up lint or dirt.
Blockage in hose. _ Remove any obstructions that restrict airflow through
hose. See page 5.
Dust cup full. _ Empty dust cup. Make sure both chambers are
empty. See page 4.
Foam filter clogged. _ Remove and clean foarn filter. See page 4.
Fine dust can block airflow through the foarn filter and
reduce suction, even if dust cup does not look full.
Filter screen clogged _ Remove and clean filter screen. See page 4.
Make sure filter screen stays in place inside dust cup
at all times.
Foam filter not _ Foam filter must be in filter frame for correct
in place, performance. See page 4.
Make sure filter frame is installed properly in filter
cover for dust cup assembly to fit back into place.
See page 4.
Switch not on _ Use 'carpet' setting for carpeted floors.
proper setting. _ Use 'hard floor' setting for hard-surface floors and
when using accessories.
Turbo nozzle clogged _ Remove and clean debris from turbo nozzle.
Quick Release handle will not
lock into vacuum cleaner.
Red 'check brush roll' or 'check
filter' indicator light is on.
Dusting brush and _ Retract telescopic wand and dusting brush to expose
telescopic wand are end of wand. See page 3.
extended. _ Place end of wand into opening on back of vacuum
and align ribs into grooves. See page 2.
bj ht rp _7;i
n d: if: n i :::::: :::::::
U h rdfl ett n::v u : :
h_: h:ro
n@d a
:: r8
o n old
_o
Brush roll not operating _ Check brush roll for threads and debris; clean if
properly or foam filter needed. See page 5.
is clogged. _ Remove and clean foaFrl filten See page 4.