User manual

electrolux 29
Minimum level adjustment of
gas oven burner
This procedure must be
undertaken by a competent and
qualified engineer only.
1. Disconnect the appliance from the
mains supply.
2. Remove all the knobs.
3. With a thin bladed screwdriver,
completely tighten the minimum level
adjustment screw (“A”).
4. Refit all the oven parts following the
above described procedure
backwards.
5. Restore the mains supply.
Do not restore the mains
supply if all the removed parts
have not been fitted back in
their original position.
6. Light the oven gas burner (see the
relevant chapter), set the gas oven
control knob on 240 and let the oven
heat for 10 minutes at least.
7.Check that the oven gas burner flame
does not fail when quickly turning the
gas oven control knob from 240 to
150.
8. Should the oven gas burner flame fail
when performing point 10, repeat the
whole procedure from point 1 to point
10, until a small regular flame is
obtained on the complete gas oven
burner crown.
A