Dust Magnet + Hepa H12 filtration 2193584-02Outline.
193584-02Outline.
한국 4–14 Electrolux Ergospace 진공 청소기를 구입해 주셔서 감사합니 다. 본 사용 설명서는 Ergospace 전 모델에 적용될 수 있습니 다. 따라서, 구입하신 모델에는 일부 부속품 또는 기능이 빠져 있을 수 있습니다. 세부 모델명 및 부속품명은 박스 겉면 라벨 에 표시되어 있습니다. 제품을 최상의 상태로 사용하려면 항상 Electrolux의 정품 부속품을 사용하십시오. 해당 정품 부속품은 사용하시는 진공 청소기에 가장 잘 맞게 특별 제작된 것입니다.
1* 1a* 2 3 4 5 6 7 8 9 4 2193584-02Outline.
English Accessories 1* 1a* 2. 3* 4* Telescopic tube Extension tube. Hose handle + hose Carpet / hard floor nozzle Dust magnet, combination carpet / hard floor nozzle 5. 6. 7* 8* 9* 3 in 1 Multi tool nozzle. Dust bag, s-bag® , dust bag holder. Turbo nozzle Parquet nozzle Easy Clean kit Safety precautions If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified person in order to avoid a hazard. Never use the vacuum cleaner if the cable is damaged.
10 11 12 14 13 16 15 18 17 19 2193584-02Outline.
English Before starting Open the front cover on the machine and check that the dust bag, s-bag® and the motorfilter are in place. (See also Replacement of filter(s)) 10 Open the back lid on the machine and check that the exhaust filter is in place. 11 Insert the hose until the catches click to engage (press the catches to release the hose). (2). Insert the hose into the hose handle until the catches click to engage (press the catches to release the hose).
20 21 22 23 5a 24 5b 8 7 25 2193584-02Outline.
English Getting the best results. 20 Accessories on board 3 in 1 multi tool nozzle to be found in the back of the cleaner. Use the nozzles as follows: Carpets: * Use the carpet/hard floor nozzle with lever in position (21). Reduce suction power for small carpets. * On the Dust Magnet nozzle (23 and 24) there is normally no need to switch mode. It can be used with brush up on all surfaces for maximal convenience with maintained excellent dust removal result.
26 29 27 28 30 31 32 33 34 2193584-02Outline.
English Replacing the dust bag, s-bag® 26 27 28 29 Open the front cover and lift out the insert holding the s-bag®. Pull the cardboard to remove the s-bag® from the insert. This automatically seals the s-bag® and prevents dust leaking out. Insert a new s-bag® by pushing the cardboard right into the end of the groove in the insert. Put the insert back into the bag compartment, and close the cover. Note. Replace the s-bag® even if it is not full (it could be obstructed).
35 36 37 38 12 2193584-02Outline.
English Cleaning the hose and nozzle The vacuum cleaner stops automatically if the nozzle, tube, hose or filters and s-bag® becomes blocked. In such cases, disconnect from mains and allow to cool for 20-30 minutes. Clear blockage and/or replace filters and s-bag® and restart. Tubes and hoses 35 36 Use a cleaning strip or similar to clear the tubes and hose. (2) Hose handle could be dismantled from hose if cleaning is needed. It may also be possible to remove the obstruction in the hose by squeezing it.
2193584-02Outline.
English Troubleshooting The vacuum cleaner does not start • Check that the cable is connected to the mains. • Check that the plug and cable are not damaged. • Check for a blown fuse. The vacuum cleaner stops • Check whether the dust bag, s-bag® is full. If so, replace it with a new one. • Is the nozzle, tube or hose blocked? • Are the filters blocked? Water has entered the vacuum cleaner It will be necessary to replace the motor at an authorised Electrolux service centre.
Share more thinking at www.electrolux.com 2193584-02Outline.