User's Manual

12 electrolux first use
The water softener must be set in
both ways: manually, using the water
hardness dial and electronically.
Setting manually
The dishwasher is factory set at
position 2.
1. Open the dishwasher door.
2. Remove the lower basket from the
dishwasher.
3. Turn the water hardness dial to
position 1 or 2 (see table).
4. Replace the lower basket.
Setting electronically
The dishwasher is factory set at
level 5.
1. Press the On/Off button. The
dishwasher must be in setting
mode.
2. Press and hold the programme
selection/cancel button until
programme light 1 flashes and
programme light 2 illuminates with
a fixed light.
3. Wait until:
- programme light 2 turns off,
- programme light 1 goes on
flashing
- the end of programme indicator
light starts flashing: the nimber of
flashes corresponds to the
current level set. The flashing is
repeated with a pause of a few
seconds. Examples: 5 flashes,
pause, 5 flashes, pause, etc... =
level 5.
4. To change the level, press the
programme selection/cancel
button. Each time the button is
pressed the level increase. (level 1
follows level10). The end of
programme light indicates the
new setting.
5. To memorise the operation, switch
off the dishwasher by pressing the
On/Off button.
156997950en prov.qxp 1/22/2007 12:31 PM Page 12