User manual

If an incorrect option is selected, the
corresponding indicator lamp flashes for
about 2 seconds. For the compatibility of
the options with the washing
programmes, refer to the chapter
'Washing programmes'.
6.7 Starting the programme
To start the selected programme, press
the button ; the corresponding pilot
light stops flashing and remains on.
On programme progress display the pilot
lights A and E illuminate to indicate that
the appliance starts operating and the
door is locked.
6.8 Altering an option or a
running programme
It is possible to change any option before
the programme carries it out.
Before you make any change, you must
pause the washing machine by pressing
the button
.
The programme can be changed as long
as the button
has not been pressed.
Changing a running programme is
possible only by resetting it. Turn the
programme selector dial to and then
to the new programme position. Start the
new programme by pressing the button
again.
6.9 Interrupting a programme
Press the button to interrupt a
programme which is running, the
corresponding light starts to flash. Press
the button again to restart the
programme.
6.10 Cancelling a programme
Turn the selector dial to position to
cancel a programme which is running.
Now you can select a new programme.
6.11 Opening the door after the
programme has started
First set the machine to pause by
pressing the button
.
After some minutes, the door can be
opened, when the following conditions
are observed:
• The water temperature is below 55°C.
• The water level is below the bottom
edge of the door.
• The machine doesn’t spin.
If you cannot open the door but it is
absolutely necessary to open it you have
to switch the machine off by turning the
selector dial to . After few minutes the
door can be opened. (Pay attention to
the water level and temperature!).
After this procedure, it will be necessary
to set the programme and the options
again and then press the button .
6.12 At the end of the
programme
The machine stops automatically.
The pilot light D illuminates to indicate
that the programme has finished. The
pilot light E goes out, the door can be
opened and the laundry can be removed.
If at the end of a programme there is
water in the tub (when
option has
been selected), to empty out the water
follow the following instructions:
• turn the programme selector dial to
• select the or programme
• press button
When the pilot light E goes out, the door
can be opened and the laundry can be
removed.
At the end of the cycle, turn the
programme selector dial to to switch
the machine off.
ENGLISH 11