User manual

CAUTION!
Never place cardboard,
wood or similar materials
under the machine to
compensate for any
unevenness in the floor.
13.4 Water inlet
WARNING!
This appliance must be
connected to a cold water
supply.
1. Connect the water inlet hose
supplied with the machine to a tap
with a 3/4" thread. Always use the
hose supplied with the appliance.
If necessary, use the suitable or
supplied restrictor (1/2”).
Do not use the hose
from your previous
machine to connect to
the water supply.
2. The machine end of the inlet hose
can be turned in any direction. Set
the hose correctly by loosening the
ring nut. After positioning the inlet
hose, be sure to tighten the ring nut
again to prevent leaks.
The inlet hose must not be lengthened. If
it is too short and you do not wish to
move the tap, you will have to purchase
a new, longer hose specially designed
for this type of use.
Before connecting up the
machine to new pipework or
to pipework that has not
been used for some time,
run off a reasonable amount
of water to flush out any
debris that may have
collected in the pipes.
13.5 Water drainage
The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink using
the plastic hose guide supplied with
the machine.
ENGLISH 23