User manual

Depress the “Start/Pause” button to
interrupt a programme which is running,
the corresponding light starts to flash.
Depress the button again to restart the
programme.
Turn the programme selector dial to “O”
to switch the machine off. Remove the
laundry from the drum and carefully check
that the drum is empty. If you do not
intend to carry out another wash, close
the water tap. Leave the door open to
prevent the formation of mildew and
unpleasant smells.
Turn the selector dial to “O” to cancel a
programme which is running. Now you
can select a new programme.
First set the machine to pause by pressing
the “Start/Pause” button. If the “Door
Lock ” light flashes and after 3 minutes
goes off, the door can be opened.
If the “Door Lock ” light does not
switch off, this means that the machine is
already heating, that the water level is
above the bottom edge of the door or that
the drum is turning. In this case the door
can not be opened.
If you can not open the door but you need
to open it you have to switch the machine
off by turning the selector dial to “O”.
After about 3 minutes the door can be
opened (pay attention to the water
level and temperature!).
The machine stops automatically. If the
Rinse Hold or No Spin option has
been selected, the phase lights “End ”
and “Door Lock ” illuminate, the
“Start/Pause” light goes off and the door
remains locked to indicate that the water
must be emptied out before opening the
door.
14 electrolux use
Interrupting a programme
Cancelling a programme
At the end of the programme
To empty out the water please read
the steps on the Rinse Hold option
paragraph.
Opening the door after the
programme has started