User manual

30 electrolux installation
Installation
Unpacking
All transit bolts and packing must be
removed before using the appliance.
You are advised to keep all transit devices
so that they can be refitted if the machine
ever has to be transported again.
Using a spanner,
unscrew and
remove the two
rear bottom
screws.
6. With the machine laid on it’s back and
5.
7.
8.
1.
Slide out the
two plastic
pins.
2.
Lay the machine on its back ensuring
that the hoses are not crushed.
Place one of
the polyethylene
angle packings
under the
machine.
Slide out the relevant pin. Cover all the
Set the machine upright and unscrew
the remaining rear screw.
open holes with
plugs which are
provided with the
Instruction
booklet.
3.
Remove the
polystyrene
block(s) protecting
the motor
4.
place the bottom cover as marked in
position A, Then push the other end
Very carefully slide
out the polythene
bag, removing it
towards the
downwards, then
pull it out. (If any)
of the cover as
directed to close
the buttom of
washing machine
(This is available in
selected models
only).