User manual

6. press the two levers and pull forward
the drainage duct to let the water flow
out;
7. when the container is full of water, put
the drainage duct back again and emp-
ty the container;
repeat this operation until water stops
flowing out;
8. if necessary clean the pump (refer to
the section ‘Drain pump’ );
9. close the drain pump door.
When you drain the water with the emer-
gency drain procedure, you must activate
again the drain system:
1. Put 2 litres of water in the main wash
compartment of the detergent dispens-
er.
2. Start the programme to drain the wa-
ter.
FROST PRECAUTIONS
If the machine is installed in a place where
the temperature could drop below 0°C, re-
move the remaining water from the inlet
hose and the drain pump.
1. disconnect the mains plug from the
mains socket.
2. close the water tap
3. unscrew the water inlet hose from the
tap;
4. put the two ends of the inlet hose in a
container and let the water flow out of
the hose.
5. empty the drain pump as described in
the ‘Emergency drain’ section.
6. when the drain pump is empty, install
the water inlet hose again.
Warning!
Make sure that the temperature is more
than 0 °C before you use the appliance
again.
The manufacturer is not responsible for
damages caused by low temperatures.
WHAT TO DO IF…
Certain problems are due to lack of simple
maintenance or oversights, which can be
solved easily without calling out an engi-
neer. Before contacting your local Service
Centre, please carry out the checks listed
below.
During machine operation it is possible that
the red pilot light of button 5 blinks to indi-
cate that the machine is not working.
It is possible to recognize the machine fault
by the number of button 5 light flashes. If
the number of flashes is different from the
ones indicated below, this is related to a
fault that you cannot solve. In this case,
contact your local Service Centre.
Press simultaneously the buttons 4 and 5
for a few seconds. The red button 5 light
will flash for a short time as described (the
green flash is not to be considered) :
•
4 flashes = «The washing machine
does not start», follow the correspond-
ing suggestions in «Possible cause/Solu-
tions» box and restart the programme.
• 1 flash = «The machine does not fill»,
follow the corresponding suggestions in
«Possible cause/Solutions» box and re-
start the programme.
•
2 flashes = «The machine does not
empty and/or does not spin», follow
the corresponding suggestions in «Possi-
ble cause/Solutions» box and restart the
programme.
Once the problem has been eliminated,
press the button 5 to restart the pro-
gramme. If after all checks, the problem
persists, contact your local Service Centre.
16 electrolux
Downloaded From WashingMachine-Manual.com Manuals