A range of complementary cleaning kits specially designed and distributed by Electrolux. To purchase any of these kits please contact Electrolux Customer Services on 08706 055 055. The Animal Kit The Car Kit Electrolux Group Floorcare Helpline Telephone: 08706 055 055 www.electrolux.co.uk Our advice To get top performance from your vacuum cleaner, use only Electrolux accessories.
Z45xx_ifu_2.qxp 2005.04.27. 10:59 Page 2 Thank you for choosing an Electrolux Power Max vacuum cleaner. These operating instructions cover all Power Max models. This means that with your specific model, some accessories may not be included.
Z45xx_ifu_2.qxp 2005.04.27.
Z45xx_ifu_2.qxp 2005.04.27. 10:59 Page 4 BEFORE STARTING 2 1 Open the dustbag cover. 2 Check that the dustbag is in place. 3 Insert the hose until the catch clicks to engage (press the catch to engage hose). 4 Attach the extension tube (Z4520) or the telescopic tube (Z4590) to the hose handle and the floor nozzle. 5 Pull out the cable and plug it in. Press the foot pedal to rewind the cable (take hold of the plug to prevent it striking you).
Z45xx_ifu_2.qxp 2005.04.27. 10:59 Page 5 REPLACING THE DUSTBAG 1 3 2 4 Replace the dustbag as soon as the indicator becomes fully illuminated. Refer to indicator with cleaner on but no accessories attached. If illuminated, attach hose, etc., and commance cleaning. Indicator may illuminate whilst cleaning please ignore. 1 Remove the hose and open the dustbag cover. 2 Pull the cardboard holder to remove the dustbag. 3 Insert a new dustbag by pushing the cardboard holder straight down in its tracks.
Z45xx_ifu_2.qxp 2005.04.27. 10:59 Page 6 Cleaning the motor filter (The motor filter should be cleaned approximately every three months, or when required for more frequent use). 1 2 3 1 2 Pull dustbag upward and remove the motor protection filter. Rinse the filter under tap water and allow 24 hours to dry. Put the filter back into the cleaner and close the cover. Filter reference number: EF 1. 3 Replacing the micro exhaust filter (The exhaust filter should be replaced approximately every 4 months).
Z45xx_ifu_2.qxp 2005.04.27. 10:59 Page 7 CLEANING THE HOSE AND NOZZLE The vacuum cleaner stops automatically if the nozzle, tube or hose becomes blocked, or the filter and dustbag are blocked. Disconnect from the mains and allow the vacuum cleaner to cool down for approximately 20-30 minutes. Clear whatever is causing the blockage and/or replace dirty filters or the full dustbag. Then restart the vacuum cleaner. Check the blockage in the hose by dropping a small coin through it.
Z45xx_ifu_2.qxp 2005.04.27. 10:59 Page 8 TROUBLESHOOTING AND CUSTOMER INFORMATION Troubleshooting The vacuum cleaner does not start 1 Check that the cable is connected to the mains. 2 Check that the plug and the cable are not damaged. 3 Check for a blown fuse. The vacuum cleaner stops 1 Check whether the dustbag is full. If so, replace it with a new one.
Z45xx_ifu_2.qxp 2005.04.27. 11:00 Page 9 ELECTRICAL SUPPLY INSTRUCTIONS Before you start …check the voltage Before connecting the cleaner to an electrical supply ensure that voltage marked on the data plate (on the underside of cleaner) is correct for your electrical supply. If is not, do not use the cleaner but refer back to your dealer. Connecting to your electrical supply Permanently connected to the cleaner is a mains supply (2-core) cable fitted with a non-rewirable plug incorporating a 13A fuse.
Z45xx_ifu_2.qxp 2005.04.27. 11:00 Page 10 When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL THE INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. WARNING To reduce the risk of fire, electric shock, or injury: • Do not use out doors or on wet surfaces. • Do not leave vacuum cleaner when plugged in. • Do not allow to be used as a toy. Close attention is necessary when used near children. Do not allow children to operate this appliance.
Z45xx_ifu_2.qxp 2005.04.27. 11:00 Page 11 GUARANTEE This guarantee is in addition to your statutory and other legal rights. Electrolux products are carefully designed, manufactured, tested and inspected and in consequence, we undertake to replace or repair any part found to be defective in material or workmanship, within one year of delivery to the original purchaser, free of charge.