e Cast Iron Bath Tub Installation Parts: Washer Brits & Lockout Pcs PCs www.kingstonbrass.com TOLL-FREE CUSTOMER SERVICE: 1-877-2-BRASS TECHNICAL SUPPORT E-mail: 12775 Reservoir Street, Chino, CA91710 TOOLS REQUIRED K Adjustable Wrench Rubber Mallet i [I Mark location Installation Steps: Step 1. Turn tub over and set on non-abrasive mat, insert pyramid bolts unto the mounting slot at the bottom of the tub. Step 2.
10 YEAR MANUFACTURER'S LIMITED WARRANTY Al parts of this Kingston Brass faucet are warranted to the original retail purchaser to be fees from defects in material and workmanship for a period of Ten(10) years from the date of purchase as shown on the purchaser's receipt This warranty is limited to defective parts only, labor charges and/or damage resulting from improper installation, repair or replacements, as well as incidental and consequential damages connected therewith are excluded.
Ned Tools: Pel) =P o Basin Wrench Adjustable Wrench Teflon Tape . L THE TRADITION OF FINE BRASS INSTALLATION INSTRUCTIONS For Use With KB's Deck Mount Tub Filler With Hand Shower % Silicone Sealant Screwdriver BEFORE BEGINNING INSTALLATION 1. Flush plumbing lines to clear any debris. 2. Shut off both supply lines after fishing. (1] &. Place a washer between the side hole of the shower 6. Turn on both hot and cold valves, let water run for ;:souls end I{m cane nut of the shows hose.
Parts: Replacement Parts: Hot Cartridge: KSRPT2000HC Cold Cartridge: KSRPT2000CC Q = Diverted Cartridge: KSRPT2001DC Handle: AERIAL CARE AND MAINTENANCE OF YOUR FAUCET Your Kingston Brass faucet has been finished to the most strict standards; however, due tn the high content of minerals in the water, your finish may appear dull and famished after time. These are some do's and don'ls to maintain the luster on your faucet for many years ta come. Do 1. Use a silicon based caulking when installing.
KINGSTON BRAS, /s THE TRADITION OF FINE BARBS www.kingstonbrass.
KINGSTON BRAS THE TRADITION OF FINE BRASS INSTALLATION INSTRUCTIONS For Use With KB's Brass Claw foot Tub Bath Drain Note:1. Observe all local plumbing and building codes. TOOLS REQUIRED Drain Wrench Adjustable Wrench Teflon Tape Silicone Sealant Screwdriver Pipe Wrench INSTALLATION INSTRUCTIONS 1.Place rubber washer (10) onto waste tube (9) and set them under the tub. 2.
KINGSTON BRASS R s Straight Bath Supply Installation fl Parts: Cone Washer & | Cone Washer & Coupling Nut & | Coupling Nut & Escutcheon Friction Ring Friction Ring | NP5} PCs PCs PCs www laughingstock TOLL-FREE CUSTOMER SERVICE: 1-877-2-BRASS TECHNICAL SUPPORT E-mail: 12775 Reservoir Street, Chino, CA 91710 Before starting the installation: Straight supply lines are designed to be installed on tubs that are configured for deck mount faucets, and should be installed at the same nectar to canter distance as th