Instruction manual

-15-
CONNECTING THE SQUELCH CONTROL TO THE PC BOARD
Cut two 3” pieces of wire from the roll of 22 guage
soild wire and strip 1/4” of the insulation off of each
end. Using these wires, solder the 100kΩ
potentiometer (VR1) to the PC board and put a
check mark in the box (!) after both wires are in
place. This part should be similar to the sketch
shown in the box, but may differ in size.
Be sure to
mechanically connect each wire as shown in
Figure 19 before soldering.
VR1 - 100kΩ Potentiometer
Squelch Control
Attach wires to points R & Q
on the PC board as shown.
Cut tab off
3” 3”
Make a good mechanical connection before
soldering.