Instruction manual

The speaker mounts behind the cluster of holes
as shown in Figure 27. Using the three black 4-40
screws, 4-40 nuts and #4 internal tooth washers,
mount the three small right angle brackets to the
speaker mounting holes. The short side of the
brackets should be against the panel. Place the
speaker between the brackets with the terminals
oriented as shown in Figure 28. Use a blunt tool
to bend the brackets over the speaker as shown in
Figure 29.
Using the hardware shown, mount the phono jack
as shown in Figure 27.
Using the hardware shown, mount the ON/OFF
switch, 2M/6M switch, Squelch pot, Volume pot,
and Tuning pot to the front panel (see Figure 30).
Orient the terminals as shown in Figure 28.
Solder the loose end of the shielded cable to the
phono jack, center conductor to the phono jack
terminal and shield to the GND terminal.
Peel the backing off of one side of the 1/2” wide,
double-sided tape and stick it to the battery clamp
as shown in Figure 31.
Peel the backing off of the other side of the
double-sided tape and stick it to the inside bottom
of the plastic case as shown in Figure 28.
With the power switch OFF, connect a 9V alkaline
battery to the battery snap and put the battery into
the battery clamp.
When the final test and alignment (next section of
manual) is completed, place the front plate on the
plastic case and insert the four nylon plugs into
the holes in each corner of the plate.
CONNECT COMPONENTS TO THE PC BOARD
-23-
Cut six 1” pieces of 22 gauge wire and strip 1/4”
of insulation off of each end. Connect the wires
to the remaining DPDT switch as shown in
Figure 26a.
Insert the six wires into holes F through K and
solder to the PC board as shown in Figure 26b.
Figure 26bFigure 26a
1/2”
FRONT PANEL ASSEMBLY