Instructions / Assembly

8
MAINTENANCE GUIDELINES
DISCONNECT POWER BEFORE PERFORMING ANY MAINTENANCE!
CLEANING
Frequent cleaning is recommended to insure proper function, optimized light output, and an
extended life. The frequency of cleaning depends on the environment in which the device operates
in: damp, smoky or particularly dirty environments can cause greater accumulation of dirt on the
fixture housing and/or light fixture optics. Clean the external surface and the front lens of the light at
least every 20 days with a soft cloth to avoid dirt/debris accumulation
NEVER use alcohol, solvents, or ammonia-based cleaners.
MAINTENANCE
Regular inspections are recommended to insure proper function and extended life. There are no user
serviceable parts inside these devices, please refer all other service issues to Eliminator Lighting.
Should you need any spare parts, please order genuine parts from Eliminator Lighting.
Please refer to the following points during routine inspections:
A detailed review by an approved electrical engineer every three months, to make sure the circuit
contacts are in good condition and prevent overheating.
Be sure all screws and fasteners are securely tightened at all times. Loose screws may fall out during
normal operation resulting in damage or injury as larger parts could fall.
Check for any deformations on the light housing, lens, gel frame, rigging hardware and rigging points
(ceiling, suspension, trussing). Deformations could allow for dust to enter into the devices. Damaged
rigging points or unsecured rigging could cause the devices to fall and seriously injure a person(s).
Electric power supply cables must not show any damage, material fatigue or sediments.