Installation manual

Door Stat 4
Door 4Door 3
PostalAutocallPower
Exit Req 4
Com
Door Stat 3
Exit Req 3
Com
Door 2
Door Stat 2
Exit Req 2
Com
or 1
Exit Req 1
Com
4
3
2
1
5
6
7
PostaAutocallPower
at 3
2
Com
In
Com
In
+12 V
Neg
at 2
2
at 1
1
5
6
7
•
•
•
Loop
Detector
Use 18-24 AWG
Use
18-24 AWG
Wiring a Door Sensing Device
Door Sensing Device / AutoCall
Door Sensing Device / AutoCall
Door Status
Common
Common
In
The EL25 can monitor the position of up to four doors/gates and may react to a change in their
status with one of the relays (not set as a control relay). For example, if a door is pried open or is
held open after its relay deactivates, the unit will record the breach in its transactions and can
perform the following actions:
Wiring the AutoCall Feature
Using the AutoCall feature, the EL25 will automatically call the main residence phone when a
driveway sensor is activated (any device that provides a contact closure ). For example, when a
visitor drives over a loop sensor that is connected to the AutoCall feature, the EL25 will call the main
residence phone automatically so the visitor can speak to the resident without pressing the call
button on the unit.
Call the main residence phone and report the status of the door.
Energize a relay to activate an alarm device such as a siren, light, or CCTV camera.
Main use is to terminate strike time early.
Loop
Sensor
Input Board
(See page 2)
Input Board
(See page 2)
Note: Additional sensing devices can be
connected to any of the 4 Door Stat inputs .
Page 13