Installation manual
O
f
f
O
f
f
On
On
On
Off
O
f
f
O
f
f
On
Off
Off
Wiring Power to the EL25 (con’t)
Powering Up and Checking the LEDs
Wiring Power to the EL25
Wiring Power to the EL25
Power Wire Specifications and Run Distances
PWR MON RST
ON
LO
HI
J400
Hard Reboot
Distance
12 VAC Power (Included)
2 -Conductor Shielded
12 VDC Power
(Not Provided)
2 -Conductor Shielded
Under 30 Feet
30 - 75 Feet
75 - 250 Feet
14
AWG
14
AWG
14
AWG
16
AWG
14
AWG
N/A
Plug the transformer into the 110 VAC outlet. Check the SYS PWR LEDs on the Main board.
If the
LO
or
HI
LEDs are lit,
press the
PWR MON RST
(Power Monitor Reset) button.
If the
LO
or
HI
LED is still lit,
check the power connections,
wiring, and transformer.
ON
LED
– Board has Power.
LO
LED
– Power is Too Low.
HI
LED
– Power is Too High.
Caution:
Not responsible for conflicts between the information listed in the above table and the requirements of your local
building codes. The information is for suggested use only. Check your local codes before installation.
J200J402
J404
J401
J406
J201
J404
J401
J404
J400
J200
J402
Page 18