Installation Instructions

12
754764-100 Rev 7 3/21
OPERATING INSTRUCTIONS
1. Fill the bath to at least 3 inches above the jets before activating the pump.
2. The pump is activated by an on/off switch. Each depression of the button switches the power either on or off.
Do not repeatedly depress the switch in rapid order if you do not see the whirlpool function right away,
as it may take a few seconds before you can see it fully operating.
3. If any factory installed ttings are removed do not operate the unit. A safety hazard may occur.
4. Do not use bubble bath when you operate the whirlpool pump.
This might cause excessive foaming.
5. Both air and whirlpool systems are plumbed in a way that water will
drain from the plumbing easily.
ON-OFF SWITCH
The whirlpool bath pump is activated by an on-off switch. Each depression of the switch will
actuate the pump. If off, one depression will turn the pump on. If on, the next depression
will turn it off.
ADJUSTABLE FLOW:
The water ow action may be adjusted from vigorous to soft by rotating the nozzle clockwise for vigorous and
counterclockwise for soft.
AIR SWITCH
Softer Massage
(counter-clockwise)
More Vigorous Massage
(clockwise)
Small Economy
Jet Assembly
Small Clean Eyeball
Jet Assembly