User Manual

15
4. Installation
Warning: The Installations of this apparatus should not be used for a substitute
for proper installation, use and maintenance of fuel burning appliances including
appropriate ventilation and exhaust systems.
4.1 Installation Procedure
1. Select a location complying with the advice in
Section 3.
2. Remove the mounting plate from the packaging/
Alarm.
3. Place the mounting plate on the ceiling/wall
exactly where you want to mount the Alarm. With a
pencil, mark the location of the two screw holes.
4. Taking care to avoid any electrical wiring in the
ceiling, drill holes using a 5.0mm drill bit through
the center of the marked locations. Push the plastic
screw anchors provided into the drilled holes.
Screw the mounting plate to the ceiling/ wall.
5. Alternatively, if desired, the CO Alarm will also
free stand on a flat surface with the mounting plate
attached.
Figure 4
6. This CO Alarm is designed for use with an ELK-M1 Control and ELK-M1XRFTWM
Wireless RF Receiver. It must be RF enrolled into the M1 Control using the
instructions which accompany the ELK Control and/or Receiver.