User Manual

19
Use the narrow nozzle of a vacuum cleaner to remove fluff and other contamination
from the cover slots and gas entry holes.
Caution: Do not paint the CO Alarm.
Remove the CO Alarm when decorating. Do not allow water or dust to contaminate
the Alarm.
Warning: Do not open or tamper with the CO Alarm. There are no user serviceable
parts inside and this can damage the Alarm.
Battery Replacement
Check the ‘Replace by’ label on the side wall - if it
has been exceeded replace the entire unit. If the
Replace by’ label on the side wall has not been
exceeded, remove the Alarm from the mounting
plate, remove the battery cover (see figure 8) and
replace the batteries. Use only Duracell Alkaline
AAA size batteries (obtained from local retailer).
Insert the new batteries with the orientation shown
on the base. Replace the battery cover and replace
the Alarm back on its mounting plate (this action
automatically switches on the batteries). Button
test the Alarm (after 15 seconds) to check
the batteries are installed correctly and that they
are not depleted.
Figure 8