User's Manual

M1KPNAV Navigator Touchscreen Keypad - User Guide
Page 8
What to do if the Alarm is Sounding
1. Proceed directly to the Keypad and enter your user code.
2. The alarm and/or keypad tone should silence.
3. The System Armed display should disappear.
4. If the alarm was accidental, contact the Central Monitoring Center to
avoid a false dispatch of the authorities.
Note: False alarms often occur when someone enters the building and
doesn’t enter their User Code prior to the entry delay time expiring. The
display shows the alarm type and first zone that tripped.
Acknowledging an Alarm
After an alarm has been silenced by a valid user code, the display will
continue to show the alarm type and zone until the Clear key is pressed or
until a valid user code is entered a second time. This “Acknowledgment” is
so that the user sees what caused the alarm after things are quieted.
To acknowledge the alarm and reset the system:
1. Press the Clear key or enter your user code again.
2. The alarm/condition will clear from the keypad display.
Troubles
There are numerous trouble conditions which the system may display:
AC Power Failure
Low Backup Battery
Telephone Line Fault
Fire Alarm Trouble
Missing Keypad, Expander (Zone or Output)
Communications Fail
Troubles are annunciated by an intermittent beeping from the keypad and a
display of the Trouble condition(s). The beeping may be silenced by
pressing the Clear key but the trouble must be acknowledged before other
keypad operation may continue.
1. To acknowledge a trouble condition enter a user code.
2. Until the trouble condition is resolved, the keypad will momentarily
flash the condition along with the normal keypad information. If a new
Trouble should occur, the keypad beeping will resume.