Installation

ManualsBrandsElkay ManualsPlumbingTubular Collection Floor Mounted Bi-Level Pedestal Outdoor Fountain includes Pet Station, Non-Filtered, Non-Refrigerated and Freeze Resistant in White

PAGE 1

4400DBFR_FTN_A LK4400DBFR_FTN_A

1000003955 (Rev. A - 06/17)

Owners Manual

4400DBFR Tubular Fountain with Pet Fountain and

Sanitary Freeze Resistant Dual Valve Control Assembly

INSTALLER

4400DBFR Fountains are among the easiest to install Fountains on the market today. To assure

you install these models easily and correctly, PLEASE READ THESE SIMPLE INSTRUCTIONS

BEFORE STARTING THE INSTALLATION. CHECK YOUR INSTALLATION FOR COMPLIANCE

WITH PLUMBING, ELECTRICAL, AND OTHER APPLICABLE CODES. After installation, save these

instructions for future reference.

Summary of content (8 pages)

PAGE 1
4400DBFR_FTN_A LK4400DBFR_FTN_A Owners Manual 4400DBFR Tubular Fountain with Pet Fountain and Sanitary Freeze Resistant Dual Valve Control Assembly INSTALLER 4400DBFR Fountains are among the easiest to install Fountains on the market today. To assure you install these models easily and correctly, PLEASE READ THESE SIMPLE INSTRUCTIONS BEFORE STARTING THE INSTALLATION. CHECK YOUR INSTALLATION FOR COMPLIANCE WITH PLUMBING, ELECTRICAL, AND OTHER APPLICABLE CODES.
PAGE 2
4400DBFR_FTN_A LK4400DBFR_FTN_A INSTALLATION INSTRUCTIONS IMPORTANT ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON IMPORTANT! INSTALLER PLEASE NOTE. THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO WATER LINES IS A COMMON PROCEDURE. THIS GROUNDING MAY BE IN THE BUILDING OR MAY OCCUR AWAY FROM THE BUILDING.
PAGE 3
4400DBFR_FTN_A LK4400DBFR_FTN_A SUGGESTED SITE PREPARATION DETAIL FOR THE 4420DBFR FTN. WHEN USING THE SANITARYFR2 VALVE 1-1/2" DRAIN TUBE (SUPPLIED BY INSTALLER) 4" PVC 1/4 BEND (SUPPLIED BY INSTALLER) 4" PVC PIPE (SUPPLIED BY INSTALLER) CONCRETE SLAB CLEANOUT PLUG FOR ACCESS (SUPPLIED BY INSTALLER) 4" 102mm MIN. 8 INCH INSIDE DIA. PVC PIPE, TRIM TO DESIRED LENGTH (SUPPLIED BY INSTALLER) 36" MIN. (914mm) 60"MAX. (1524mm) FROST LINE PVC 8" x 8" x 4" COMBINATION "Y" & 1/8 BEND REDUCING ASSY.
PAGE 4
400DBFR_FTN_A LK4400DBFR_FTN_A SUGGESTED SITE PREPARATION DETAIL FOR THE 4420DBFR FTN. WHEN USING THE SANITARYFR2 VALVE 1-1/2 DRAIN TUBE SUPPLIED WITH FTN. ( 6 ) 1/2" ( 13mm ) DIA. HOLES EQUALLY SPACED ON A 12" ( 305mm ) BOLT CENTER AIR GAP ASSY. SUPPLIED WITH VALVE O 14"' 356mm 26"' 660mm 10"' O 254mm A 22"' 559mm 12"' 305mm 41 7/16"' O 1053mm 1-1/2 DRAIN TUBE SUPPLIED BY INSTALLER O 10"' 254mm A 30"' 762mm SEE DETAIL A Detail A 8"' 203mm 4"' 102mm 36"' MIN. 914mm 60" MAX.
PAGE 5
4400DBFR_FTN_A D E LK4400DBFR_FTN_A F G C B FOUNTAIN CONNECTIONS H A PLUMBING CONDUIT (BY INSTALLER) TO VALVE FIG. 3 INSTRUCTIONS FOR CONNECTING TUBES FROM VALVE TO FOUNTAIN(S) Step 1 - Insert the 1/8” O.D. tube(s) (Labeled A & B) into the connector(s) (provided with fountain). Insert the 1/8” O.D. tube(s) coming from the fountain(s) push button actuator(s) into the connector(s). Trim any excess length. Step 2 - Secure the 1/8” O.D. tube(s) (Labeled C & D) to the waste line assembly.
PAGE 6
4400DBFR_FTN_A LK4400DBFR_FTN_A Stream Height Adjustment 6 3 14 2 7 7 5, 13 8 SEE DETAIL B 15 8 8 16 8 4 12 15 17 DETAIL B 17 FIG. 4 1000003955 (Rev.
PAGE 7
4400DBFR_FTN_A LK4400DBFR_FTN_A The Following Items are included with the SanitaryFR2 Valve PARTS LIST ITEM NO. PART NO.
PAGE 8
4400DBFR_FTN_A LK4400DBFR_FTN_A TROUBLESHOOTING AND MAINTENANCE Insufficient Bubbler Flow: Check that the shut-off valve is wide open. Verify minimum 20 PSI supply pressure. Clean inlet strainer screen located in the valve body. Clean rubber orifice in flow control located below frost line in bushing between barb fitting and valve. No Flow: Check for leaks in the air tubing going from the push button to the valve. Make sure the air tubing compression nut is hand tight.