Use and Care Manual

Page 24
ENLZSTL8WS_1F
1000002120 (Rev. E - 09/17)
Enhanced EZH2O Error Codes
Error
Code
Error Description Corrective Action
E001 Evaporator Thermistor Open Circuit • Verify cable connector is plugged into control board (10 pin connector on
harness # 0000001225)
• If error repeats, contact certied service professional
E002 Evaporator Thermistor Short Circuit • Check for excessive moisture on control board around 10 pin connector
on harness # 0000001225
• If error repeats, contact certied service professional
E003 Evaporator Low Temperature • Unplug unit for at least 30 seconds and restart
• Monitor compressor for run-on condition
• If error repeats, contact certied service professional
E004 Condenser Thermistor Open Circuit • Verify cable connector is plugged into control board (10 pin connector on
harness # 0000001225)
• If error repeats, contact certied service professional
E005 Condenser Thermistor Short Circuit • Check for excessive moisture on control board around 10 pin connector
on harness # 0000001225
• If error repeats, contact certied service professional
E006 Condenser Over Temperature • Clean condenser if needed
• Check for proper fan operation (powers on, not obstructed, etc.)
• Contact certied service professional
E007 Not Used
E008 Not Used
E009 Too Many Compressor Cycles • Contact certied service professional
E010 Not Used
E011 Evaporator not cooling/Thermistor not measuring • Contact certied service professional
E012 Bottle ller area obstructed • Clean lens on IR sensor
• Unplug unit for at least 30 seconds and restart
• If error repeats, replace IR sensor with 1000002434 KIT - IR SENSOR
E013 Missing or Incompatible Filter • Check that lter is installed correctly (label facing forward, white tag fac-
ing back)
• Unplug unit for at least 30 seconds and restart
• Replace lter
• Replace lter head assembly with repair kit - 1000002030 KIT - FILTER
HEAD-BRKT-FTGS
• If error repeats, contact certied service professional
E014 Missing NFC Board • Unplug unit for at least 30 seconds and restart
• Verify cable connector is plugged into NFC board on lter head assembly
• Verify cable connector is plugged into control board (10 pin connector on
harness # 0000001225)
• Replace lter head assembly with repair kit - 1000002030 KIT - FILTER
HEAD-BRKT-FTGS
• If error repeats, contact certied service professional
E015 Missing LED Board • Verify cable connector is plugged into LED board in the bottle ller tower
assembly
• Verify cable connector is fully plugged into the basin from the tower as-
sembly.
• Verify cable connector is plugged into control board (18 pin connector on
harness # 1000001608)
• Replace LED lter status board with repair kit - 1000002436 KIT - ALPHA
NUMERIC LED BOARD
• Replace tower cable harness – 1000001609 HARNESS-BASIN FEED
TO BF
• Replace fountain cable harness – 1000001608 HARNESS-CNTRL
BOARD TO BASIN FEED