Computer Hardware User Manual

4.2.2 External Resistor
Connect an external resistor between terminal J1/9 (ECLC) and terminal J1/8 (ECLRET).
The resistor value is given by:
0 < RECLC < 36.4 K (1/8 Watt)
At RECLC greater than 36.4 K, the current limit will be internally clamped to the nominal
value.
IC(nom) is the nominal continuous current limit of the amplifier.
4.2.3 External Current Limit - Peak (ECLP)
The peak current limit of the Dragonfly and Butterfly amplifiers can be scaled down by an
external voltage or by an external resistor connected between pin J1/14 (ECLP) and J1/8
(ECLRET).
4.2.4 External Voltage
An external positive voltage (0 to 3.75 V) to terminal J1/14 (ECLP) in reference to terminal
J1/8 (ECLRET) will control the peak current limit from zero to Ip(nom).
The voltage is internally clamped to 3.75 V whenever the external VECLP is higher than 3.75 V.
The external voltage source must be able to source/sink at least ±0.2 mA.
The maximum absolute VECLP allowed to be connected is 5 V.
(Kohm) = 37.4 *
R
ECLC
Ic(new)
Ic(nom)
- 1
(Kohm) = 37.4 *
R
ECLC
(Kohm) = 37.4 *
R
ECLC
Ic(new)
Ic(nom)
- 1
V
ECLP
Ip(new) =
3.75V
* Ip(nom)
V
ECLP
Ip(new) =
3.75V
* Ip(nom)
Dragonfly/Butterfly Installation Guide Servo Control Operation
MAN-DRBUIG (Ver. 1.1)
4-2