Installation guide

Quick Installation Guide
00825-0100-4648, Rev CC
February 2012
Rosemount 648 Wireless
6
STEP 1 CONTINUED...
6. Close the housing cover and tighten to safety specification. Always ensure a proper seal
by installing the electronics housing covers so that metal touches metal, but do not over
tighten.
7. Position the antenna such that it is vertical, either straight up or straight down.The
antenna should be approximately three feet (0,91 m) from any large structures or
buildings to allow clear communication to other devices.
STEP 2: VERIFY OPERATION
Operation can be verified in four locations: at the device via the LCD, by using the Field
Communicator, at the Gateway via the Smart Wireless Gateway’s integrated web server, or
via AMS
Suite: Intelligent Device Manager.
Local Display
During normal operation, the LCD should display the PV value at the update rate up to 1
minute intervals. Refer to the Rosemount 648 Manual for error codes and other LCD
messages. Press the Diagnostic button to display the TAG, Device ID, Network ID,
Network Join Status and Device Status screens.
00825-0100-4648_CC.fm Page 6 Monday, February 13, 2012 12:48 PM