Instructions / Assembly

10
ETL Model No.: CF860
3. Ceiling Fan Assembly (Continued)
6 TO 9
INCHES
HANGER BALL
WHITE WIRE
B
LACK WIRE
1
/2-INCH
3.13
T
he fan comes with black and white leads that are
80-inches long.
M
easure up approximately 6 to 9-inches above top of
hanger ball/4.5” downrod assembly (Figure 13).
Cut off excess leads and strip back insulation 1/2-inch
from end of leads.
FLOOR
CEILING
AT
LEAST
7'
Figure 14
Figure 13
4. How to Hang Your Ceiling Fan
The fan must be hung with at least 7' of clearance from
floor to blades (Figure 14).
WARNING
!
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
WARNING
!
To avoid fire or shock, follow all wiring instructions
carefully.
Any electrical work not described in these
instructions should be done or approved by a licensed
electrician.
WARNING
!
4.1
Disconnect electrical power to the branch circuit at the
circuit breaker or fuse box before attempting to install
the ceiling fan mounting plate on the outlet box.