Instructions / Assembly

13
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF860
6. Optional Installation of No-Light Plate Assembly
Skip to Section 6.4 if supplied light kit is
not already installed.
6.1
Removal of the Shade from the Light Kit Adapter:
Rotate the Shade counter-clockwise to loosen from the
Light Kit Adapter (Figure 21).
Remove the Shade from the Light Kit Adapter
(Figure 21).
Store Shade in a safe location for future installation.
LIGHT KIT
ADAPTER
RAISED
DIMPLES (3)
SHADE
FLAT AREA OF
SHADE (3)
ROTATE COUNTER-
CLOCKWISE
Figure 21
6.2
Removal of the Light Kit Assembly from the Light
Kit Adapter:
Loosened the Light Kit Adapter #6-32 x .375” two pan
head screws located in the key hole slots.
Remove the remaining Light Kit Adapter #6-32 x .375”
pan head screw (Figure 22). Retain for future use.
Rotate the Light Kit Assembly counter-clockwise to
disengage the two screw heads in the key hole slots for
removal of Light Kit Assembly.
LOOSENED LIGHT KIT ADAPTER
PAN HEAD SCREWS (2)
LIGHT KIT
ASSEMBLY
LIGHT KIT ADAPTER
PAN HEAD SCREW (1)
LIGHT KIT
ADAPTER
ROTATE COUNTER-
CLOCKWISE
Figure 22
5. Light Kit Assembly (Continued)
5.4
Place the shade into the opening of the Light Kit
Adapter, aligning the three flat areas on the top edge of
the shade with the three raised dimples on the Light Kit
A
dapter and turn the shade clockwise until it stops
(Figure 20).
NOTE: Periodically check that the shade is seated
fully clockwise in the Light Kit Adapter.
LIGHT KIT
ADAPTER
RAISED
DIMPLES (3)
SHADE
FLAT AREA OF
SHADE (3)
ROTATE
CLOCKWISE
Figure 20