Instructions / Assembly

19
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF860
8.6
Disconnect electrical power to the branch circuit at the
circuit breaker or fuse box before attempting to install
the ceiling fan wall control into the outlet box.
Before installing wall control, place wall control in “OFF”
mode by pushing “ON/OFF” switch to the “OFF”
position.
Connect one black wire of wall control to the “hot” wire.
Securely connect wires with wire connectors supplied
(Figure 33).
Connect one black wire of wall switch to the “load”
(black) wire in wall box. Securely connect wires with
wire connector supplied.
FAN/LIGHT WALL
CONTROL
WALL BOX
BLACK
B
L
K
HOT
SWITCH COVER
DECORATIVE WALL PLATE
SCREWS (2)
NEUTRAL
WIRES
T
O
1
2
0
V
A
C
S
O
U
R
C
E
T
O
L
O
A
D
G
R
O
U
N
D
Figure 33
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
WARNING
!
Do not connect any neutral (white) wire to this control.
Incorrect wiring will damage this control.
WARNING
!
8.5
This control is designed to operate only one ceiling fan
NOTE: Electric connections should be in
accordance with the National Electrical Codes and
a
ll Local Codes. Before starting, disconnect power
to the circuit at the fuse box or circuit breaker
panel.
Remove the faceplate and screws from the existing wall
switch. Pull switch out from wall outlet box.
Determine the “hot” wire and the “load” wire and
disconnect these wires from existing control
(Figure 32).
Do not attempt to disconnect any wires not already
connected to existing control.
FACEPLATE
WALL
SWITCH
O
UTLET
BOX
SCREWS
Figure 32
8. Wall Control Installation (Continued)
Screw wall control into wall box using the supplied
screws. Leave wall control in “OFF” mode until fan
installation is completed.
The wall control is supplied with a white, ivory, and
almond color switch covers. Choose the finish that best
suits your needs and snap the cover onto the wall
control (Figure 33).
Install decorator wall plate using the two screws
provided with wall plate. Leave wall control in “OFF”
mode until fan installation is completed (Figure 33).
Skip to Section 8.7 if using a 3-way switch
installation.
SINGLE-POLE INSTALLATION