Instructions / Assembly

21
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF860
8. Wall Control Installation (Continued)
3-WAY INSTALLATION
(
One fan controlled by two different wall controls)
(See Figures 35 and 36).
8.7
Disconnect electrical power to the branch circuit at the
circuit breaker or fuse box before attempting to install
the ceiling fan wall control into the outlet box.
At all wall box locations remove faceplates and screws
from existing controls. Pull controls out from wall boxes
and determine which wall box contains the “hot” lead
and which wall box contains the “load” wire. Also,
identify traveler wires which are common to both wall
boxes. Disconnect wires from existing controls only. Do
not attempt to disconnect any wires not already
connected to existing controls.
Before installing wall control, place wall control in “OFF”
mode by pushing “ON/OFF” switch to the “OFF”
position.
HOT
BLACK
FAN/LIGHT
WALL
CONTROL
TRAVELER
WIRE
BLK BLK
LOAD
GROUND
NEUTRAL
BLACK
BLK
Figure 35
T
urning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse or circuit breaker box before
wiring. All wiring must be in accordance with National
and Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
WARNING
!
Do not connect any neutral (white) wire to this control.
Incorrect wiring will damage this control.
WARNING
!
Install a wall control in the wall box containing the “hot”
wire first. Connect the black wire of the wall control to
the “hot” wire. Securely connect wires with wire
connectors supplied.
Connect one black wire of the wall control to both
remaining traveler wires in the wall box and secure with
wire connector supplied.
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
WARNING
!