AM/FM Clock Radio with Sure Alarm OWNER'S MANUAL CK5029 Visit our web site at www.emersonradio.com CK5029_030405.
CAUT I ON TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
Thank you for purchasing this Emerson Compact AM/FM Clock Radio with Sure Alarm. The large LED display is designed to be highly visible and easily readable from anywhere in your room. You can set alarm to wake you to buzzer or radio if you wish. All of the controls are easy to see and easy to use. The radio has a slide rule dial for easy tuning. The Sure Alarm battery back up system will remember the time and alarm settings of course, but it can do more than that.
IMPORTANT NOTES • Avoid installing this unit in places • Operate controls and switches as exposed to direct sunlight or close to described in the manual. heat radiating appliances such as • Before turning on the power, make electric heaters, on top of other stereo certain that the power cord is properly equipment that radiates too much installed. heat, places lacking ventilation or dusty • When moving the set, be sure to first areas, places subject to constant disconnect the AC power cord.
PREPARATION FOR USE Unpacking And Set Up • Remove the radio from the carton and remove all packing material from the radio. We suggest that you save the packing material, if possible, in the unlikely event that your radio ever needs to be returned for service. The original carton and packing material is the only safe way to pack your radio to protect it from damage in transit. • Remove any descriptive labels or stickers on the front or top of the cabinet.
To install the battery • Open the battery compartment cover on the bottom of the radio by pressing on the locking tab in the direction of the “arrow” and lift it up. • Connect the 9-volt battery to the battery terminal. It can only be connected one way. • Push the battery into the battery compartment and replace the cover.
Power Source This radio is designed to operate on normal 120V 60Hz AC power only. Do not attempt to operate the radio on any other power source. You could cause damage to the radio that is not covered by your warranty. This radio should be connected to an AC outlet that is always ‘live’. Do not connect it to an outlet that is controlled by a wall switch. When the power to the radio is interrupted, the Sure Alarm battery back up system takes over to maintain the time and alarm settings.
Protect Your Furniture This model is equipped with non-skid rubber 'feet' to prevent the product from moving when you operate the controls. These 'feet' are made from non-migrating rubber material specially formulated to avoid leaving any marks or stains on your furniture. However certain types of oil based furniture polishes, wood preservatives, or cleaning sprays may cause the rubber 'feet' to soften, and leave marks or a rubber residue on the furniture.
LOCATION OF CONTROLS AND INDICATORS Top Panel 9 10 8 11 7 6 12 5 4 3 2 13 1 14 Front Panel 16 15 17 18 Right Side Panel 12 11 13 8 CK5029_030405.
1.) MINUTE SET Button. 2.) CLOCK Setting Button. 3.) SLEEP Button. 4.) ALARM Setting/Reset Button. 5.) HOUR SET Button. 6.) OFF-ON-BUZZ-AUTO Selector Switch. 7.) AUTO ON Indicator. 8.) AC Power Cord. 9.) DIMMER HI(High)/LO(Low) Selector Switch (Back Cabinet). 10.) Speaker. 11.) VOLUME Control. 12.) BAND (FM/AM) Selector Switch. 13.) TUNING Control. 14.) SNOOZE/SLEEP OFF Button. 15.) AM indicator. 16.) Time Display. 17.) Dial Pointer. 18.) Back Up Battery Compartment (Bottom Cabinet). 9 CK5029_030405.
OPERATING INSTRUCTIONS Setting The Clock When you connect the radio to your AC outlet for the first time, the display will begin flashing “12:00” AM. The flashing will stop when you set the time. AM indicator 1.) Depress the CLOCK button together with the HOUR button to set the display to the correct Hour. 2.) Depress the CLOCK button together with the MINUTE button to set the display to the correct Minute.
Setting The Wake Up Time 1.) Depress the ALARM button together with the HOUR button to set the display to the correct Hour. 2.) Depress the ALARM button together with the MINUTE button to set the display to the correct Minute. Note: Observe the AM indicator to make sure you have set the clock to the correct wake up hour, AM or PM. If the AM indicator is ‘On’the time displayed is AM. If the AM indicator is ‘Off’the time displayed is PM.
Listening To The Radio Note: Set the clock before turning the radio ‘On’for the first time. 1.) Set the BAND selector to the desired band, AM or FM. 2.) Set the VOLUME control to a low setting. 3.) Set the OFF-ON-BUZZ-AUTO selector switch to the “ON” position to turn the radio ‘On’. 4.) Select your desired station with the TUNING control. 5.) Adjust the VOLUME control to the desired setting. 6.
Wake To Radio 1.) Turn the radio ‘On’and select the band, station, and volume level that you wish to hear when the alarm comes ‘On’. 2.) Reconfirm the wake up time setting. 3.) Set the OFF-ON-BUZZ-AUTO selector switch to the “AUTO” position. The AUTO ON indicator comes ‘On’. 4.) At the selected wake up time the radio will turn ‘On’. It will play for 1 hour and 59 minutes and then shut ‘Off’automatically. 5.) To stop the radio sooner, press the ALARM button.
Sleep To Music Timer The sleep to music timer allows you to fall asleep to music for up to 1 hour and 59 minutes, and then shuts the radio ‘Off’automatically. The sleep timer can be activated when the OFF-ON-BUZZ-AUTO selector switch is set to the OFF, BUZZ or AUTO positions. 1.) Depress the SLEEP button to start the sleep timer. The display indicates "0:59" and the radio turns ‘On’. 2.) To adjust the amount of sleep timer operation, continue to hold the SLEEP button and depress the MINUTE button.
CARE AND MAINTENANCE There are no user serviceable parts inside this radio. Please refer all service problems to a qualified service facility. See the warranty page of this manual for further details. If the cabinet becomes dusty, wipe the exterior with a soft dust cloth only. Never use dusting sprays or polishes on the cabinet. If the cabinet becomes dirty or smudged with fingerprints it may be wiped with a soft cloth that has been slightly dampened with a mild soap and water solution.
LIMITED WARRANTY Emerson Radio Corp. warrants manufacturing defects in original material, including original parts and workmanship, under normal use and conditions, for a period of ninety (90) days from the date of original purchase in the U.S. With your dated proof of purchase, we will provide repair service at no charge for labor and parts at an authorized Depot Repair Facility, or replace the product in our discretion.
EMERSON Part No. : 16-2984 502-01 CK5029_030405.
