User Guide

11-18 • E2 RX/BX/CX I&O Manual 026-1610 Rev 13 14-SEP-2011
user). If there is no “L” beside the definition, the value is
not part of a logging group and therefore will not be
logged.
11.5.4 Setting Up Logging
To begin logging setup, go to the Logging Setup menu:
1. Press
 for the Main Menu.
2. Press
 System Configuration.
3. Press
 Logging Setup.
From this menu, you can control different logging
aspects:
• Access Log Group summary screen (or Base Log if
no additional log groups exist) to set logging
parameters
• Add a new log group and automatically enter edit
mode
• Delete a log group
• Displays a report of all logged points for the entire
system
For Base Log setup, select 1. Log Groups from this
menu:
The summary screen for Logging Groups will open
where a variety of log parameters can be viewed. Log
group name, configured resolution setting, number of days
to keep logs, the amount of available logging resources,
number of analog and digital points associated with this
logging group, status, and more can all be seen from this
summary screen.
Highlight the desired logging group and press

to open the setup screen for that log group:
From this screen, logging group configuration can be
specified. Group name, interval between log records,
mode, start date and time, duration of logs, log resolution,
points, percentage used, status, and enable/disable logging
can be configured. (See the online help for each property
Figure 11-8
- Logging Setup Menu
Figure 11-9 - Summary Screen for Logging Groups
Figure 11-10 - Logging Setup