User Guide

I-4 • E2 RX/BX/CX I&O Manual 026-1610 Rev 13 14-SEP-2011
pulsed 11-13
pump down delay 11-12
reverse cycle hot gas 11-12
run-off time 11-12
standard circuits 11-6
defrost states 11-6
defrost type 11-6
electric defrost 11-6
emergency defrost 11-7
pulsed defrost 11-7
termination 11-7
timed and reverse air 11-6
termination 11-13
pulsed defrost 11-13
temperature 11-13
timed (off-cycle) 11-12
Dehumidification 11-52
Demand
explanation of 11-43
Demand Control 11-34
Demand Defrost. See Defrost, demand.
Detailed Setpoint Change Logging 11-56
Log Information 11-56
Logged Changes 11-57
Unlogged Changes 11-57
Dewpoint Probe 3-11
location 3-11
mounting 3-11
Dewpoint Probe. See Sensors, Dewpoint Probe.
DHCP Enabled 10-11
Digital Discus Compressor 11-1, 11-2
Digital Scroll Compressor Support 11-2
Digital Sensor Control 11-38
Dip Switches
baud rate 6-3
input type 9-1
network settings 6-3
Discontinued boards
16AIe 2-11
8ROe 2-11
ESR8 2-12
Discus 6-8
Discus Compressor 11-1, 11-2
Door Switches 11-7
-E-
E2 1-1
blank face 3-3
Box-to-Box 1-6
capabilities 1-1
connection to other 1-6
documentation 1-6
Echelon connectors 4-2
Echelon jumpers 4-2
installation instructions 4-7
mounting
blank face 3-3
recessed mount 3-1
retrofit 3-2
standard mount 3-1
networking
introduction to 1-4
Quick Start 10-1
repeater
part number for manual 1-6
routers
part number for manual 1-6
RS-232 Baud Rate 10-12
RS485 port 4-2
RS485 termination jumpers 4-2
specifications 2-2
user’s guide 1-6
EC-2 Case Controller
defined 2-11
detail 2-11
Echelon Network
checking boards online 10-16, 12-11
daisy-chaining 8-1
device wiring 8-1
E2 RX 1-5
installing Echelon devices 8-3
location of connectors on E2 4-2
maximum number of nodes 8-2
Neuron ID number
manual entry of 10-19
overview 8-1
peripherals for the 1-5
powering Echelon devices 8-3
problems with F-2
subnets
setting the number 10-2, 10-16
termination block installation 8-3
unit controllers 10-2, 10-16