Instruction manual

Instruction Manual
760006-A
September 2001
11-32 Appendices Rosemount Analytical Inc. A Division of Emerson Process Management
Model NGA 2000 Platform
14. Select the type of output desired (0-
20mA, 4-20mA, or 0 - 5V)
15. Choose whether to hold the output during
calibration
16. Verify that the choices shown on the
lower three lines are correct.
17. Press the ADJUST key to calibrate this
output channel
18. Repeat for any other output channels in-
stalled.
19. Press the left arrow key to return to the
previous menu
20. Select Relay output setup…
21. Go through the same procedure to select
the signals desired for each relay (this
function is not supported by all modules)
22. Select Serial interface setup…
23. Verify the correct transmission settings
24. Select AK protocol