Instruction manual

Instruction Manual
760006-A
September 2001
3-10 Operation Rosemount Analytical Inc. A Division of Emerson Process Management
Model NGA 2000 Platform
a. Single Component Display
The Measure menu that displays after
startup is the Single Component display
of the first Analyzer. If other Analyzer
modules are connected to the Platform, it
is possible to display them using the fol-
lowing steps to change the channel of the
single component display:
Figure 3-11. Single Component Display
CLD
Sample flow: 1300 ml/min 200 1500
Sample press: 4.0 hPa 50.0 490.0
Ozonator: OFF – PRESS. SW.
Converter temp: 30.9 C 150.0 500.0
Dis
p
la
y
Status… Main… Channel BasicCal
0.00 Ran
g
e: 1 10.00
7.50
ppm NO
MLT/CH1/R2
Dis
p
la
y
Status… Main… Channel BasicCal
0.00 Ran
g
e: 2 5.00
2.50
% CO2
Temperature: 37.0 C 0.0 100.0
Maintenance-Request No
Any-alarms: No
Operation: Ready
CLD
Sample flow: 1300 ml/min 200 1500
Sample press: 4.0 hPa 50.0 490.0
Ozonator: OFF – PRESS. SW.
Converter temp: 30.9 C 150.0 500.0
Dis
p
la
y
Status… Main… Channel BasicCal
0.00 Ran
g
e: 1 10.00
7.50
ppm NO
Single Component Display of the first
channel.
Press Channel (F4) to change to the Single
Component Display of any other installed
Analyzer modules.
Example:
Changing from CLD (channel 1) to CO
2
(channel 2). (The display may look different
depending on installed Analyzers.)
Continue pressing Channel (F4) to display
the desired channel, ultimately returning to
the first channel.