Instruction manual

Instruction Manual
760006-A
September 2001
Rosemount Analytical Inc. A Division of Emerson Process Management Operation 3-11
Model NGA 2000 Platform
CLD
Sample flow: 1300 ml/min 200 1500
Sample press: 4.0 hPa 50.0 490.0
Ozonator: OFF – PRESS. SW.
Converter temp: 30.9 C 150.0 500.0
Dis
p
la
y
Status… Main… Channel BasicCal
0.00 Ran
g
e: 1 10.00
7.50
ppm NO
Select
Status… Ta
g
s Off LCDReset
7.50
2.50
95.00
CLD
ppm NO
MLT/CH1
% CO2
MLT/CH2
ppm CO
0.00
[
1
]
10.00
0.000
[
2
]
5.00
0.00
[
2
]
250.00
>
MLT/CH1
Dis
p
la
y
Status… Main… Channel BasicCal
0.00 Ran
g
e: 2 5.00
2.50
% CO2
Temperature: 37.0 C 0.0 100.0
Maintenance-Request No
Any-alarms: No
Operation: Ready
b. Multi Component Display
If other Analyzer modules are connected
to the NGA 2000 Platform, it is possible to
display up to five. Use the procedure in
Figure 3-12 to change from the single
component display to the multi compo-
nent displays.
Figure 3-12. Multi Component Display
To select a single channel display in the multi
channel display, enable the select symbol (>)
by pressing the Select (F1) key or the ↓
cursor key.
Use the ↑ ↓ cursor keys to go to the line for
the desired channel, press Select (F1).
When the channel is marked, press Select
(F1) again to display the single component.
From the Single Channel Display (Measure)
press Display (F1) to change to the Multi
Component Display of all other installed
Analyzer modules.
(Changing to the multi component display
can be done from each single component
display.)
Each bargraph shows the start and end of
the range for the respective channel. The
number in parentheses indicates the number
of the selected range for that channel. (F.S. =
fullscale)
(Display may look different depending on
installed Analyzers.)
Tags Off (F3) key will turn Analyzer tags on
or off.